| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| In the Linux kernel, the following vulnerability has been resolved:
ASoC: mediatek: mt8192: Check runtime resume during probe
The MT8192 AFE probe enables runtime PM temporarily while reinitializing
the regmap cache from hardware, but it uses pm_runtime_get_sync()
without checking the return value. If runtime resume fails, probe keeps
going without the device necessarily being accessible, and
pm_runtime_get_sync() may leave the PM usage count incremented.
The regmap_reinit_cache() failure path also returns before dropping the
temporary PM reference and before clearing pm_runtime_bypass_reg_ctl.
Use pm_runtime_resume_and_get() so resume failures do not leak a usage
count, and clear the temporary bypass flag after dropping the probe PM
reference on all regmap_reinit_cache() outcomes. |
| In the Linux kernel, the following vulnerability has been resolved:
fbdev: nvidia: fix potential memory leak in nvidiafb_probe()
In nvidiafb_probe(), the memory allocated for modelist in
nvidia_set_fbinfo() is not freed in the subsequent error paths.
Fix that by calling fb_destroy_modelist(). |
| In the Linux kernel, the following vulnerability has been resolved:
power: supply: charger-manager: fix refcount leak in is_full_charged()
In is_full_charged(), power_supply_get_by_name() is called to
obtain a reference to the fuel_gauge power supply. If the
voltage check (uV >= desc->fullbatt_uV) succeeds, the function
returns true directly without releasing the reference, leaking
the refcount.
Fix this by setting a flag and jumping to the out label where
power_supply_put() properly drops the reference. |
| In the Linux kernel, the following vulnerability has been resolved:
ntfs: fix hole runlist memory leak in insert range error path
ntfs_non_resident_attr_insert_range() allocates hole_rl before mapping the
whole runlist. If ntfs_attr_map_whole_runlist() fails, the error path drops
ni->runlist.lock and returns without freeing hole_rl. This leaks memory
of sizeof(*hole_rl) * 2 bytes.
Fix this memory leak by freeing hole_rl before returning from
that error path, matching the later error paths in the same function. |
| In the Linux kernel, the following vulnerability has been resolved:
ntfs: fail attrlist updates when the superblock is inactive
generic_shutdown_super() clears SB_ACTIVE before evicting cached inodes.
If eviction selects the fake inode for a base inode's unnamed
$ATTRIBUTE_LIST attribute, ntfs_evict_big_inode() drops the fake inode's
reference on the base inode while the fake inode is still hashed and marked
I_FREEING.
That iput can synchronously write back the base inode. The writeback path
may update mapping pairs and call ntfs_attrlist_update(), which
unconditionally calls ntfs_attr_iget() for the same $ATTRIBUTE_LIST fake
inode. VFS then finds the I_FREEING inode and waits for eviction to finish,
but the current task is still inside that eviction path, causing a
self-deadlock in find_inode().
Fix this by mirroring the teardown guard used by __ntfs_write_inode():
once SB_ACTIVE has been cleared, do not try to iget the attribute-list
fake inode. Return -EIO so teardown aborts the update instead of waiting on
the inode it is evicting. |
| In the Linux kernel, the following vulnerability has been resolved:
fbdev: tdfxfb: fix potential memory leak in tdfxfb_probe()
In tdfxfb_probe(), the memory allocated for modelist using
fb_videomode_to_modelist() when CONFIG_FB_3DFX_I2C is defined, is not
freed in the subsequent error paths.
Fix that by calling fb_destroy_modelist(). |
| In the Linux kernel, the following vulnerability has been resolved:
fbdev: s3fb: fix potential memory leak in s3_pci_probe()
In s3_pci_probe(), the memory allocated for modelist using
fb_videomode_to_modelist() is not freed in subsequent error paths.
Fix that by calling fb_destroy_modelist() |
| In the Linux kernel, the following vulnerability has been resolved:
fbdev: i740fb: fix potential memory leak in i740fb_probe()
In i740fb_probe(), the memory allocated in fb_videomode_to_modelist()
for modelist is not freed in the error paths. Fix that by calling
fb_destroy_modelist(). |
| In the Linux kernel, the following vulnerability has been resolved:
fbdev: radeon: fix potential memory leak in radeonfb_pci_register()
The function radeonfb_pci_register() allocates memory for modelist
(by calling radeon_check_modes() which calls fb_add_videomode()).
The memory is appended to info->modelist, but is not freed in subsequent
error paths. Fix this by calling fb_destroy_modelist(). |
| In the Linux kernel, the following vulnerability has been resolved:
fbdev: hecubafb: fix potential memory leak in hecubafb_probe()
The memory allocated for pagerefs in fb_deferred_io_init() is not freed
on the error path. Fix it by calling fb_deferred_io_cleanup(). |
| In the Linux kernel, the following vulnerability has been resolved:
fbdev: broadsheetfb: fix potential memory leak in broadsheetfb_probe()
The memory allocated for pagerefs in fb_deferred_io_init() is not freed
on the error path. Fix it by calling fb_deferred_io_cleanup(). |
| In the Linux kernel, the following vulnerability has been resolved:
remoteproc: qcom: Fix leak when custom dump_segments addition fails
Free allocated minidump_region 'name' in qcom_add_minidump_segments()
when failing before adding the region to 'dump_segments'. Otherwise,
the 'name' is not tracked and is never freed by qcom_minidump_cleanup().
Return error when adding to 'dump_segments' fails. |
| In the Linux kernel, the following vulnerability has been resolved:
nvdimm/btt: Free arena sub-allocations on discover_arenas() error path
Memory allocated by btt_freelist_init(), btt_rtt_init(), and
btt_maplocks_init() is not freed on some discover_arenas() error
paths. This leaks memory when arena discovery fails.
Add the missing kfree() calls to release the allocations before
returning an error.
[ as: commit message and log edits ] |
| In the Linux kernel, the following vulnerability has been resolved:
i2c: imx: fix locked bus on SMBus block-read of 0 (atomic)
SMBus 3.1 6.5.7 allows a Block Read byte count of 0, but the atomic
(polling) path rejects it as -EPROTO. Worse, it returns without a
NACK+STOP: the next receive cycle has already started, so the target
keeps holding SDA and the bus stays stuck until a power cycle for
this i2c controller.
Reading I2DR to obtain the count likewise arms the next byte on the
count > I2C_SMBUS_BLOCK_MAX path, which also returned -EPROTO directly
and left the bus held.
Handle both: NACK the in-flight dummy byte (TXAK) and extend msgs->len so
the existing last-byte handling emits STOP; the dummy byte is discarded.
A count of 0 is a valid empty block read; a count above
I2C_SMBUS_BLOCK_MAX is still reported as -EPROTO, but only after the bus
has been released.
The interrupt-driven path has the same flaw from a later commit and is
fixed separately, as it carries a different Fixes: tag and stable range. |
| In the Linux kernel, the following vulnerability has been resolved:
tpm: tpm_tis_spi: Use wait_woken() in wait_for_tmp_stat()
wait_event_interruptible_timeout() evaluates its condition after setting
the current task state to TASK_INTERRUPTIBLE.
With CONFIG_DEBUG_ATOMIC_SLEEP this triggers a warning when the IRQ wait
path is used:
tpm_tis_status()
tpm_tis_spi_read_bytes()
tpm_tis_spi_transfer_full()
spi_bus_lock()
mutex_lock()
Address this with the following measures:
1. Call wait_tpm_stat_cond() only while tasking is running.
2. Use wait_woken() to wait for changes. |
| In the Linux kernel, the following vulnerability has been resolved:
irqchip/crossbar: Use correct index in crossbar_domain_free()
crossbar_domain_free() resets the domain data and then uses the nulled
out irq_data->hwirq member as index to reset the irq_map[] entry and to
write the relevant crossbar register with a safe entry. That means it
never frees the correct index and keeps the crossbar register connection
to the source interrupt active.
If it would not reset the domain data, then this would be even worse as
irq_data->hwirq holds the source interrupt number, but both the map and
register index need the corresponding GIC SPI number and not the source
interrupt number. This might even result in an out of bounds access as
the source interrupt number can be higher than the maximal index space.
Fix this by using the GIC SPI index from the parent domain's irq_data. |
| In the Linux kernel, the following vulnerability has been resolved:
fpga: microchip-spi: fix zero header_size OOB read in mpf_ops_parse_header()
mpf_ops_parse_header() reads header_size from the bitstream at
MPF_HEADER_SIZE_OFFSET (24). When header_size is zero, the expression
*(buf + header_size - 1) reads one byte before the buffer start.
Since initial_header_size is set to 71 in mpf_ops, the fpga-mgr core
guarantees the buffer is large enough to reach MPF_HEADER_SIZE_OFFSET.
The only real gap is the zero header_size case, which cannot be
resolved by providing a larger buffer, so return -EINVAL. |
| In the Linux kernel, the following vulnerability has been resolved:
ocfs2: reject non-inline dinodes with i_size and zero i_clusters
On a volume mounted without OCFS2_FEATURE_INCOMPAT_SPARSE_ALLOC, a
non-inline regular file with non-zero i_size and zero i_clusters is
structurally malformed: the extent map declares no allocated clusters yet
the size header claims content exists. Keep rejecting that shape, but
express it through a shared predicate so the same invariant is available
to normal inode reads and online filecheck.
The same zero-cluster shape is also malformed for non-inline directories.
ocfs2 directory growth allocates backing storage before advancing i_size,
and ocfs2_dir_foreach_blk_el() later walks until ctx->pos reaches
i_size_read(inode). A forged directory dinode with a huge i_size and no
clusters would repeatedly fail on holes while advancing through the
claimed size.
Sparse regular files remain exempt: on sparse-alloc volumes, truncate can
legitimately grow i_size without allocating clusters. System inodes and
inline-data dinodes also retain their separate storage rules.
Mirror the check in ocfs2_filecheck_validate_inode_block() as well.
filecheck reports through its own error namespace, so malformed
size/cluster state is logged as a filecheck invalid-inode result rather
than via ocfs2_error(), but it must not proceed into
ocfs2_populate_inode(). |
| In the Linux kernel, the following vulnerability has been resolved:
batman-adv: frag: free unfragmentable packet
The caller of batadv_frag_send_packet() assume that the skb provided to the
function are always consumed. But the pre-check for an empty payload or the
zero fragment size returned an error without any further actions.
A failed pre-check must use the same error handling code as the rest of the
function. |
| In the Linux kernel, the following vulnerability has been resolved:
ocfs2: fix NULL h_transaction deref in ocfs2_assure_trans_credits
[BUG]
A direct write over unwritten extents can panic the kernel in
ocfs2_assure_trans_credits() when the journal aborts during DIO
completion. The crash is a general protection fault from a NULL pointer
dereference.
[CAUSE]
ocfs2_dio_end_io_write() loops over a direct write's unwritten extents,
marking each written under a single journal handle. If the journal
aborts (for example after an I/O error) while the extent tree is being
updated, the handle is left aborted with its transaction pointer
cleared. The extent merge treats that failure as not critical and
reports success, so the loop keeps using the handle.
ocfs2_assure_trans_credits() reads the handle's remaining credits
without first checking whether the handle is aborted, and that read
dereferences the cleared transaction pointer.
[FIX]
A journal abort is recorded in the handle itself, so callers are
expected to test the handle rather than rely on a returned error.
Make ocfs2_assure_trans_credits() do that, as the other ocfs2 journal
helpers already do, and return -EROFS when the handle is aborted. |
