| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| In the Linux kernel, the following vulnerability has been resolved:
ASoC: codecs: lpass-tx-macro: Fix enum kcontrol accesses
The "DEC0 MODE" to "DEC7 MODE" controls are enumerated, but
tx_macro_dec_mode_get() and tx_macro_dec_mode_put() access their
value through ucontrol->value.integer.value[0] (a long) instead of
ucontrol->value.enumerated.item[0] (an unsigned int).
This same pattern was fixed in the sibling drivers by
commit bcfe5f76cc40 ("ASoC: codecs: rx-macro: fix accessing array
out of bounds for enum type") and
commit 0ea5eff7c606 ("ASoC: codecs: va-macro: fix accessing array
out of bounds for enum type"), but tx-macro was missed.
On 64-bit kernels built with CONFIG_SND_CTL_DEBUG, the elem value
sanity check catches the 4 bytes written past the enumerated item
and every read of these controls fails with -EINVAL:
snd-sm8250 sound: control 2:0:0:DEC0 MODE:0: access overflow |
| In the Linux kernel, the following vulnerability has been resolved:
ASoC: SOF: ipc4-pcm: Continue the pipeline trigger in case of IPC timeout
Ignore IPC errors for pipeline state change if the firmware state is
crashed or the IPC has timed out.
If the firmware has crashed the kernel still needs to go through the state
changes to reset its internal to be able to correctly work the next time
the DSP is booted up.
The case with IPC timeout is a bit more problematic, but it has been
rootcaused to be the result of system scheduling blockage and the firmware
did actually received and handled the message, but the reply handling got
blocked by issues outside of the SOF stack.
So far the best way to handle this is to continue with setting the state. |
| In the Linux kernel, the following vulnerability has been resolved:
Input: byd - synchronize timer deletion before freeing private data
byd_disconnect() uses timer_delete() before freeing the driver's private
data. This does not wait for a running byd_clear_touch() callback, which
dereferences the private data and its psmouse pointer. A callback racing
with disconnect can therefore access the private data after it has been
freed. The timer can also still be re-armed by byd_process_byte() while
the disconnect is in progress.
Use timer_shutdown_sync() before freeing the private data: it waits for
a running callback and turns any later re-arm attempt into a no-op. |
| In the Linux kernel, the following vulnerability has been resolved:
gpio: ml-ioh: use raw_spinlock_t for the register lock
ioh_irq_type() is registered as the irq_chip .irq_set_type callback and
takes chip->spinlock with spin_lock_irqsave(). This callback is reached
from __setup_irq() -> __irq_set_trigger() -> chip->irq_set_type() while
the caller holds desc->lock, a raw_spinlock_t, with hardirqs disabled.
That context is not sleepable, but on PREEMPT_RT a regular spinlock_t is
an rtmutex-backed sleeping lock, so acquiring it there is invalid.
ioh_irq_enable() and ioh_irq_disable() take the same lock from the
.irq_enable/.irq_disable callbacks, which are likewise invoked with
desc->lock held.
Convert the register lock to raw_spinlock_t. The same lock also
serializes the GPIO direction/value callbacks and the suspend/resume
register save/restore, and those critical sections only perform short
sequences of MMIO register accesses (ioread32()/iowrite32()); the
.irq_set_type callback additionally emits a dev_warn() on an unsupported
type. None of these are sleepable operations, so keeping this register
lock non-sleeping is appropriate for the irqchip callbacks and does not
change the GPIO-side locking contract.
This is the same fix as commit a02b8950d619 ("gpio: pch: use
raw_spinlock_t for the register lock"); this driver shares the same
structure as gpio-pch. |
| In the Linux kernel, the following vulnerability has been resolved:
libceph: fix OOB read in decode_watchers() via missing bounds check
ceph_start_decoding() validates that struct_len bytes remain in the
buffer after the encoding header, but accepts struct_len=0 as valid:
ceph_decode_need(p, end, 0, bad) always passes. When a malicious or
compromised OSD sends an obj_list_watch_response_t reply with
struct_len=0, ceph_start_decoding() returns success with p == end,
leaving zero bytes guaranteed for subsequent reads.
The immediately following ceph_decode_32(p) in decode_watchers() has
no preceding bounds check. With p == end this is a 4-byte read past
the validated buffer boundary. The garbage value is then passed
directly to kzalloc_objs() as the watcher count.
The sibling function decode_watcher() already uses the safe variants
(ceph_decode_copy_safe, ceph_decode_64_safe, ceph_decode_skip_32)
after its own ceph_start_decoding() call. decode_watchers() is the
only site that uses the bare variant, confirming an oversight.
Fix by replacing ceph_decode_32(p) with ceph_decode_32_safe(p, end,
*num_watchers, bad), consistent with the established pattern.
Attacker model: a malicious or compromised OSD in a multi-tenant Ceph
deployment (e.g. cloud) can trigger this against any kernel client
that calls CEPH_OSD_OP_LIST_WATCHERS, without any further privileges
beyond OSD session establishment.
[ idryomov: trim changelog ] |
| In the Linux kernel, the following vulnerability has been resolved:
s390/vfio_ccw: Cancel existing workqueues
The initialization of the io_work and crw_work workqueues begs the
question of whether they should be un-initialized. Add the corresponding
cleanup tags in _release_dev to ensure work isn't dispatched after
the private struct is free'd. |
| In the Linux kernel, the following vulnerability has been resolved:
s390/vfio_ccw: Ensure index for read/write regions are within range
The introduction of the capability chain rightly clamped the
region indexes to the range of the capabilities itself, but
neglected to do so for the existing read/write regions which
should also be enforced. |
| In the Linux kernel, the following vulnerability has been resolved:
s390/vfio_ccw: Ensure first IDAW remains constant
The first IDAW in a list does not need to be on a 2K/4K boundary
like all others, and so is read separately to accurately calculate
the size of the buffer needed to read the full IDAL.
Verify that the address found in the first IDAW is unchanged between
reads, to ensure a consistent set of IDAWs being worked with. |
| In the Linux kernel, the following vulnerability has been resolved:
s390/vfio_ccw: Move cp cleanup out of not operational
The fsm_notoper() routine is called when the device has been
lost, and is (by definition) no longer operational. Since this
can happen asynchronously from the normal behavior of the
driver, the cleanup may happen when holding other locks
in the calling sequence (notably, the cio subchannel lock).
Push the cleanup of the private->cp resources to a workqueue,
where it can be done out from under that lock sequence and
a future patch can safely manage the locking requirements. |
| In the Linux kernel, the following vulnerability has been resolved:
s390/vfio_ccw: Selectively expand io_mutex
The io_mutex was defined to serialize the io_regions, but then has
also sort of been associated with the I/O themselves because of
the close relationship they share.
With the handful of races that are possible, the choices are either to:
A) expand the scope of io_mutex to close these remaining windows, or
B) reduce the scope of io_mutex to just io_region, and introduce a new
lock mechanism for the remaining I/O resources
This patch implements A, since B brings with it a lot more interactions
that would need to be tracked and kept in a correct hierarchy. It also
takes advantage of the workqueue element for cp_free() that now gets
called out of fsm_notoper(), which could be invoked out of an interrupt
context and thus cannot acquire a mutex itself. |
| In the Linux kernel, the following vulnerability has been resolved:
s390/vfio_ccw: Implement a crw lock
Unlike the channel_program struct, which covers synchronous I/O
submissions and asynchronous interrupts, the CRW region relies
exclusively on asynchronous events coming from hardware.
Implement a lock to manage the list of those payloads, to ensure
they are read cohesively. |
| In the Linux kernel, the following vulnerability has been resolved:
drm/amdgpu: disallow multiple FENCE chunks in one submit
amdgpu_cs_pass1() dispatches on chunk_id once per chunk without
rejecting repeated ids. p->uf_bo is a single-slot field, so a
submission carrying two AMDGPU_CHUNK_ID_FENCE chunks runs
amdgpu_cs_p1_user_fence() twice, and the second run overwrites
p->uf_bo with a freshly referenced BO without dropping the reference
taken by the first.
amdgpu_cs_parser_fini() only unrefs the final p->uf_bo, so every FENCE
chunk but the last leaks a BO reference. The leaked BO outlives handle
close and process exit.
Reject duplicate FENCE chunks the same way commit fec5f8e8c6bc
("drm/amdgpu: disallow multiple BO_HANDLES chunks in one submit") did
for p->bo_list.
(cherry picked from commit 665b1fc2a1845206408f9a2c6da67101789edb82) |
| Unauthenticated Cross Site Scripting (XSS) in WP w3all phpBB <= 3.0.6 versions. |
| Unauthenticated Cross Site Scripting (XSS) in CozyStay <= 1.10.0 versions. |
| Subscriber SQL Injection in Like Button Rating <= 2.6.61 versions. |
| Unauthenticated Cross Site Scripting (XSS) in CP Media Player <= 1.3.0 versions. |
| Editor Arbitrary File Upload in Fluent Boards Pro <= 2.0.11 versions. |
| Editor Privilege Escalation in FluentCRM Pro <= 3.1.12 versions. |
| Contributor PHP Object Injection in Booking and Rental Manager <= 2.7.5 versions. |
| Improper Neutralization of Special Elements used in an LDAP Query ('LDAP Injection') vulnerability in Apache APISIX.
A caller who holds valid credentials for one entry in the LDAP directory can authenticate through APISIX as a consumer mapped to a different entry, one the plugin's configured scope was meant to keep out of reach.
This issue affects Apache APISIX: from 2.11.0 through 3.17.0.
Users are recommended to upgrade to version 3.18.0, which fixes the issue. |
