| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| In the Linux kernel, the following vulnerability has been resolved:
net/sched: act_pedit: fix TOCTOU heap OOB write in tc offload
There is a TOCTOU race condition in flower lockless approach between sizing
a flow_rule buffer and filling it.
[email protected] reports:
The cls_flower classifier operates with TCF_PROTO_OPS_DOIT_UNLOCKED
(fl_change runs without RTNL), while RTM_NEWACTION holds RTNL, so the
independent locking domains make the race reachable in practice. KASAN
confirms:
BUG: KASAN: slab-out-of-bounds in tcf_pedit_offload_act_setup+0x81b/0x930
Write of size 4 at addr ffff888001f27520 by task poc-toctou/312
The buggy address is located 0 bytes to the right of
allocated 288-byte region [ffff888001f27400, ffff888001f27520)
(cache kmalloc-512)
Note: The result is a heap OOB write attacker-controlled content into the
adjacent slab object (requires CAP_NET_ADMIN).
The fix introduces reading tcfp_nkeys under act->tcfa_lock in all places
using a new tcf_pedit_nkeys_locked() which replaces the old tcf_pedit_nkeys().
Additionally we close the remaining TOCTOU window between the sizing read and
the fill reads by more careful accounting.
Rather than silently truncating the key count, which leads to incorrect
action semantics offloaded to hardware and secondary OOB writes if
the remaining capacity is zero or consumed by prior actions, we enforce
remaining capacity checks and return -ENOSPC if the required space exceeds
the remaining capacity. |
| In the Linux kernel, the following vulnerability has been resolved:
net/mlx5: LAG, Fix off-by-one in single-FDB error rollback
On failure at index i, the reverse cleanup loop in
mlx5_lag_create_single_fdb() starts from i, so the failed index
itself is rolled back. That can operate on uninitialized state or
double-tear-down a rule the add_one path already self-rolled-back.
Start the rollback from i - 1 so only successfully-installed entries
are undone. |
| In the Linux kernel, the following vulnerability has been resolved:
HID: bpf: Fix hid_bpf_get_data() range check
hid_bpf_get_data() returns a pointer into the HID-BPF context data when
the caller-provided offset and size fit inside ctx->allocated_size.
The current check adds rdwr_buf_size and offset before comparing the
result against ctx->allocated_size. Since both values are unsigned, a
very large size can wrap the sum below ctx->allocated_size and make the
helper return a pointer even though the requested range is not contained
in the backing buffer.
Use check_add_overflow() to reject wrapped range ends before comparing
the requested range end against ctx->allocated_size. |
| In the Linux kernel, the following vulnerability has been resolved:
ipv4: fib: Don't ignore error route in local/main tables.
When CONFIG_IP_MULTIPLE_TABLES is enabled but no rule is added,
fib_lookup() performs route lookup directly on two tables.
Since the first lookup does not properly bail out, the result
of an error route in the merged local/main table could be
overwritten by another route in the default table:
# unshare -n
# ip link set lo up
# ip route add 192.168.0.0/24 dev lo table 253
# ip route add unreachable 192.168.0.0/24
# ip route get 192.168.0.1
192.168.0.1 dev lo table default uid 0
cache <local>
Once a random rule is added, the error route is respected:
# ip rule add table 0
# ip rule del table 0
# ip route get 192.168.0.1
RTNETLINK answers: No route to host
Let's fix the inconsistent behaviour. |
| In the Linux kernel, the following vulnerability has been resolved:
md/raid1: fix writes_pending and barrier reference leaks on write failures
raid1_make_request() acquires a writes_pending reference with
md_write_start() before calling raid1_write_request(). Several failure
paths in raid1_write_request() complete the bio and return without
reaching the normal write completion path, causing the corresponding
md_write_end() to be skipped.
Make raid1_write_request() return a status indicating whether the write
request was successfully queued. This allows raid1_make_request() to
call md_write_end() when raid1_write_request() fails.
Additionally, if wait_blocked_rdev() fails after wait_barrier()
succeeds, the associated barrier reference is not released.
Call allow_barrier() before returning from that path to keep the barrier
accounting balanced. |
| In the Linux kernel, the following vulnerability has been resolved:
apparmor: aa_label_alloc use aa_label_free on alloc failure
aa_label_alloc() allocates a secid before allocating or taking the label
proxy. If the later proxy step fails, the error path only freed the label
memory, leaking any resources initialized by aa_label_init().
Use aa_label_free() on the failure path so partially initialized labels
release their secid and other label resources before the backing memory is
freed. |
| Null pointer dereference vulnerability in the browser module. Impact: Successful exploitation of this vulnerability may affect availability. |
| In the Linux kernel, the following vulnerability has been resolved:
netfilter: flowtable: support IPIP tunnel with direct xmit
The combination of IPIP tunnel with direct xmit, eg. bridge device,
breaks because no dst_entry is provided to check the skb headroom and to
set the iph->frag_off field. This leads to invalid dst usage and can
trigger a crash in the tunnel transmit path.
Fix this by moving dst_cache and dst_cookie out of the runtime union so
that they can be shared by neighbour, xfrm, and direct tunnel flows.
For FLOW_OFFLOAD_XMIT_DIRECT tuples carrying tunnel metadata, preserve
route state in these shared fields and release it through the common
dst release path.
Since dst_entry is now available to the three supported xmit modes and
dst_release() already deals with NULL dst, remove the xmit type check
in nft_flow_dst_release(). Moreover, skip the check if the dst entry
is NULL in nf_flow_dst_check() which is now the case for the direct
xmit case.
Based on patch from Rein Wei <[email protected]>. |
| In the Linux kernel, the following vulnerability has been resolved:
netfilter: nft_fib: reject fib expression on the netdev egress hook
A fib expression in a netdev egress base chain dereferences nft_in(pkt),
NULL on the transmit path, causing a NULL pointer dereference at eval.
nft_fib_validate() masks the hook with NF_INET_* values, but netdev hook
numbers are a separate enum that aliases them (NF_NETDEV_EGRESS ==
NF_INET_LOCAL_IN), so an egress chain passes validation and then faults.
Add nft_fib_netdev_validate() that limits each result/flag to the netdev
hook where the device it reads exists: the input-device cases (OIF,
OIFNAME, ADDRTYPE with F_IIF) to ingress, the output-device case (ADDRTYPE
with F_OIF) to egress, ADDRTYPE with no device flag to both. Also restrict
nft_fib_validate() to NFPROTO_IPV4/IPV6/INET so its NF_INET_* masks are
not applied to another family's hooks. |
| In the Linux kernel, the following vulnerability has been resolved:
netfilter: nf_queue: pin bridge device while NFQUEUE holds fake dst
The br_netfilter fake rtable is embedded in struct net_bridge and is
attached to bridged packets with skb_dst_set_noref(). If such a packet is
queued to NFQUEUE, __nf_queue() upgrades that fake dst with
skb_dst_force().
At that point the queued skb can hold a real dst reference after bridge
teardown has started. The problem is not that every bridged packet needs
its own dst reference. The problem is that NFQUEUE can keep the bridge
private fake dst alive after unregister begins.
Fix this by keeping the bridge fake dst model unchanged and pinning the
bridge master device only while the packet sits in NFQUEUE. Record the
bridge device in nf_queue_entry when the queued skb carries a bridge fake
dst, take a device reference for the queue lifetime, and drop it when the
queue entry is freed.
Also make sure queued entries are reaped when that bridge device goes
down, and drop the redundant nf_bridge_info_exists() test from the fake
dst detection.
This keeps netdev_priv(br->dev) alive until verdict completion, so the
embedded fake rtable and its metrics backing storage cannot be freed out
from under dst_release(). It also avoids the constant refcount bump and
avoids using ipv4-specific dst helpers for IPv6 bridge traffic. |
| A security flaw has been discovered in GL.iNet A1300, AX1800, AXT1800, BE1400, BE3600, BE6500, BE9300, BE10000, E5800, MT2500, MT3000, MT3600BE, MT5000, MT6000, X2000, X3000 and XE3000 up to 4.8.x. Affected by this issue is the function ui.update_langs of the component Language Update. Performing a manipulation of the argument hour/min/week results in code injection. The attack can be initiated remotely. The vendor explains: "After our investigation, we have confirmed that the vulnerability described (...) does indeed exist." |
| A flaw was found in GLib. The D-Bus client-side implementation of the DBUS_COOKIE_SHA1 SASL authentication mechanism does not validate the cookie_context parameter received from the server. A malicious D-Bus server can supply a cookie_context containing path traversal sequences, causing the client to read an arbitrary file and exfiltrate sensitive data by verifying guessed file contents against a generated hash. |
| A flaw was found in GLib. An off-by-one error can occur in the g_key_file_get_locale_string_list function in the gkeyfile.c file when loading a key file with an empty value. This flaw can cause an out-of-bounds access of 1 byte or a denial of service when the out-of-bounds access crosses a page boundary. |
| A flaw was found in GLib. A buffer over-read can occur in g_io_channel_read_line_backend() in the giochannel.c file when a custom line terminator with a length greater than one is set, causing memcmp to read past the GString buffer. This vulnerability can cause a minor information disclosure of 7 bytes or a denial of service when the buffer over-read crosses a page boundary. |
| A flaw was found in GLib. A buffer over-read can occur in the g_regex_replace function when used with the `G_REGEX_RAW` compile flag and case-change replacement escapes because the string_append function processes matched substrings using UTF-8 functions that assume valid UTF-8 input, even when the string is treated as raw bytes. This vulnerability can cause a minor information disclosure of 1-5 bytes and a denial of service when the buffer over-read crosses a page boundary. |
| A flaw was found in GLib. An out-of-bounds read of only 2 bytes can occur in the g_date_time_get_ymd function in the glib/gdatetime.c file when an invalid GDateTime object produced by the g_date_time_add_full function is processed. This flaw can corrupt the date output and potentially cause logic errors that may lead to a denial of service. |
| A flaw was found in GLib. An off-by-one error can occur in the gvs_tuple_is_normal function in the glib/gvariant-serialiser.c file when doing an alignment padding check because the bounds check uses > instead of >=, causing an out-of-bounds read of only 1 byte. This issue can cause a minor information disclosure of 1 byte and a denial of service when the out-of-bounds read crosses a page boundary. |
| A denial-of-service and resource exhaustion vulnerability exists within the `GDBus` component of GLib. The `gdbusauth` authentication mechanism fails to enforce proper length limitations on data lines read from a client. An unauthenticated local or remote attacker can exploit this lack of input validation by sending excessively long streams of data, causing the application to consume massive amounts of system memory and CPU, potentially leading to a crash or system hang. |
| In the Linux kernel, the following vulnerability has been resolved:
KVM: x86: Nullify irqfd->producer if updating IRTE for bypass fails
Nullify irqfd->producer if updating the IRTE for bypass fails, as leaving a
dangling pointer will result in a use-after-free if the irqfd is reachable
through KVM's routing, but the producer is freed separately. E.g. for VFIO
PCI, the producer is embedded in struct "vfio_pci_irq_ctx" and freed when
the vector is disabled, which can happen independent of routing updates.
[sean: drop PPC change, massage changelog] |
| In the Linux kernel, the following vulnerability has been resolved:
KVM: TDX: Reject concurrent change to CPUID entry count
Reject KVM_TDX_INIT_VM if userspace changes cpuid.nent between the
initial read and the subsequent copy of the initialization data.
tdx_td_init() first reads user_data->cpuid.nent to size the flexible
kvm_tdx_init_vm copy. The copied structure also contains cpuid.nent,
and that field can differ from the value used to size the allocation if
userspace modifies the input concurrently. setup_tdparams_cpuids() later
passes init_vm->cpuid.nent to kvm_find_cpuid_entry2(), which uses it as
the array bound for the copied entries.
Require the copied count to match the value used to size the allocation
so that CPUID parsing cannot access beyond the entries actually copied. |
