| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| In the Linux kernel, the following vulnerability has been resolved:
netfilter: flowtable: use correct direction to set up tunnel route
The layer 2 encapsulation and layer 3 tunnel information in the xmit
path is taken from the other tuple, because the tunnel information that
is included in the tuple for hashtable lookups is also used to perform
the egress encapsulation in the transmit path.
This patch uses the correct direction when setting up the tunnel, the
original proposed patch to address this fix uses the reversed direction.
While at it, remove the redundant check to call dst_release() to drop
the reference on the dst that was obtained from the forward path, which
is not useful in the direct xmit path unless tunneling is performed. |
| In the Linux kernel, the following vulnerability has been resolved:
gpu: host1x: Fix device reference leak in host1x_device_parse_dt() error path
After device_initialize(), the embedded struct device in struct
host1x_device should be released through the device core with
put_device().
In host1x_device_add(), if host1x_device_parse_dt() fails, the current
error path frees the object directly with kfree(device). That bypasses
the normal device lifetime handling and leaks the reference held on the
embedded struct device.
The issue was identified by a static analysis tool I developed and
confirmed by manual review.
Fix this by using put_device() in the host1x_device_parse_dt() failure
path. |
| In the Linux kernel, the following vulnerability has been resolved:
gpu/buddy: bail out of try_harder when alignment cannot be honoured
The try_harder contiguous fallback could return a range whose start
offset did not match the caller's min_block_size. When a candidate's
start is misaligned, realign it: free the misaligned run and reallocate
exactly @size at the next lower min_block_size boundary. This keeps the
returned size unchanged with no surplus to trim, and rejects the request
only when no aligned candidate fits.
v2: align misaligned candidates down to min_block_size instead of
bailing out, for both the RHS and LHS paths (Matthew). |
| In the Linux kernel, the following vulnerability has been resolved:
selinux: check connect-related permissions on TCP Fast Open
Similar to Landlock, SELinux was not updated when TCP Fast Open
support was introduced to ensure connect-related permissions are
checked when using TCP Fast Open. Update its socket_sendmsg() hook to
call selinux_socket_connect() when MSG_FASTOPEN is passed. |
| In the Linux kernel, the following vulnerability has been resolved:
selinux: avoid sk_socket dereference in selinux_sctp_bind_connect()
selinux_sctp_bind_connect() dereferences sk->sk_socket to pass a
struct socket * to selinux_socket_bind() and
selinux_socket_connect_helper(). However, when the hook is invoked
from the ASCONF softirq path (sctp_process_asconf), there is no file
reference guaranteeing that sk->sk_socket is non-NULL. The setsockopt
callers (bindx, connectx, set_primary, sendmsg connect) hold a file
reference and are not affected.
Both selinux_socket_bind() and selinux_socket_connect_helper()
immediately resolve sock->sk, never using the struct socket * for
anything else. Refactor the inner logic into helpers that take a
struct sock * directly so that selinux_sctp_bind_connect() never needs
to touch sk->sk_socket at all. |
| In the Linux kernel, the following vulnerability has been resolved:
leds: uleds: Fix potential buffer overread
The name string supplied by userspace is not guaranteed to be
null-terminated, so using strchr() on it might result in a buffer
overread. The same thing will happen when said string is used by
the LED class device.
Fix this by using strnchr() instead and explicitly check that
the name string is properly null-terminated. |
| In the Linux kernel, the following vulnerability has been resolved:
mfd: sm501: Fix reference leak on failed device registration
When platform_device_register() fails in sm501_register_device(), the
embedded struct device in pdev has already been initialized by
device_initialize(), but the failure path only reports the error and
returns without dropping the device reference for the current platform
device:
sm501_register_device()
-> platform_device_register(pdev)
-> device_initialize(&pdev->dev)
-> setup_pdev_dma_masks(pdev)
-> platform_device_add(pdev)
This leads to a reference leak when platform_device_register() fails.
Fix this by calling platform_device_put() before returning the error.
The issue was identified by a static analysis tool I developed and
confirmed by manual review. |
| In the Linux kernel, the following vulnerability has been resolved:
x86/virt/sev: Revert "Drop WBINVD before setting MSR_AMD64_SYSCFG_SNP_EN"
Revert
99cf1fb58e68 ("x86/virt/sev: Drop WBINVD before setting MSR_AMD64_SYSCFG_SNP_EN").
Section 8.8 of the SNP spec says:
Before invoking SNP_INIT_EX with INIT_RMP set to 1, software must ensure
that no CPUs contain dirty cache lines for the memory containing the RMP.
Cachelines can be moved from cache to cache in a dirty state. The
wbinvd_on_all_cpus() before SNP_INIT_EX flushes the caches for each CPU, but
if the IPIs for WBINVD race with this dirty cacheline movement, it is possible
that they may not get flushed, violating the firmware requirement.
Doing wbinvd_on_all_cpus() before setting SNPEn is safer since the RMP
table is not yet in use.
[ Heroically bisected by Srikanth. ]
[ bp: Massage commit message. ] |
| In the Linux kernel, the following vulnerability has been resolved:
s390/perf_cpum_cf: Add missing array_index_nospec() to __hw_perf_event_init()
ev variable is userspace controlled via event->attr.config and used
as an array index after bounds checking, but without speculation
barriers.
Add the missing array_index_nospec() call to prevent speculative
execution. |
| In the Linux kernel, the following vulnerability has been resolved:
batman-adv: access unicast_ttvn skb->data only after skb realloc
The pskb_may_pull() called by batadv_get_vid() could reallocate the buffer
behind the skb. Variables which were pointing to the old buffer need to be
reassigned to avoid an use-after-free.
This was done correctly for the ethernet header but missed for the
unicast_packet pointer. |
| In the Linux kernel, the following vulnerability has been resolved:
batman-adv: tt: avoid request storms during pending request
batadv_send_tt_request() allocates a tt_req_node when none exists for the
destination originator node. This should prevent that a multiple TT
requests are send at the same time to an originator.
But if allocation of the send buffer failed, this request must be cleaned
up again. But indicator for such a failure is "ret == false". But the
actual implementation is checking for "ret == true".
The check must be inverted to not loose the information about the TT
request directly after it was attempted to be sent out. This should avoid
potential request storms. |
| In the Linux kernel, the following vulnerability has been resolved:
batman-adv: clean untagged VLAN on netdev registration failure
When an mesh interface is registered, it creates an untagged struct
batadv_meshif_vlan on top of it via the NETDEV_REGISTER notifier. But in
this process, another receiver of this notification can veto the
registration. The netdev registration will be aborted because of this veto.
The register_netdevice() call will try to clean up the net_device using
unregister_netdevice_queue() - which only uses the .priv_destructor to
free private resources. In this situation, .dellink will not be called.
The cleanup of the untagged batadv_meshif_vlan must thefore be done in the
destructor to avoid a leak of this object. |
| In the Linux kernel, the following vulnerability has been resolved:
batman-adv: frag: fix primary_if leak on failed linearization
If the skb has a frag_list, it must be linearized before it can be split
using skb_split(). But when this step failed, it must not only free the skb
but also take care of the reference to the already found primary_if. |
| In the Linux kernel, the following vulnerability has been resolved:
batman-adv: mcast: avoid OOB read of num_dests header
Before the access to struct batadv_tvlv_mcast_tracker's num_dests, it is
attempted to check whether enough space is actually in the network header.
But instead of using offsetofend() to check for the whole size (2) which
must be accessible, offsetof() of is called. The latter is always returning
0. The comparison with the network header length will always return that
enough data is available - even when only 1 or 0 bytes are accessible.
Instead of using offsetofend(), use the more common check for the whole
header. |
| In the Linux kernel, the following vulnerability has been resolved:
nvdimm/btt: Free arenas on btt_init() error paths
The arenas allocated by discover_arenas() or create_arenas() are not
freed on some error paths in btt_init(). This leaks memory when BTT
initialization fails.
Call free_arenas() from the affected error paths to release the
allocations.
[ as: commit message and log edits ] |
| In the Linux kernel, the following vulnerability has been resolved:
sunrpc: harden rq_procinfo lifecycle to prevent double-free
The svc_release_rqst() function executes the callback inside
rqstp->rq_procinfo->pc_release. However, if a worker thread begins
processing a new request and encounters an early error path (e.g.,
unsupported protocol, short frame, or bad auth) before a valid
rq_procinfo is installed, a stale release hook can be re-triggered
against reused state from the previous RPC, resulting in a double-free
or use-after-free vulnerability.
Harden the lifecycle of rq_procinfo by:
1. Ensuring svc_release_rqst() always clears rq_procinfo after the
optional pc_release() call, regardless of whether the hook exists.
2. Explicitly clearing rq_procinfo at request entry in svc_process()
before any early decode or drop paths.
3. Ensuring svc_process_bc() does the same at backchannel entry.
This guarantees that error flows will not encounter a non-NULL stale
rq_procinfo pointer when there is nothing to release. |
| In the Linux kernel, the following vulnerability has been resolved:
lockd: Plug nlm_file leak when nlm_do_fopen() fails
A client can repeatedly drive nlm_do_fopen() failures by presenting
file handles that the underlying export rejects. After kzalloc_obj()
succeeds in nlm_lookup_file(), the freshly allocated nlm_file is not
yet inserted into nlm_files[]. The nlm_do_fopen() failure path jumps
to out_unlock, which releases nlm_file_mutex and returns without
freeing the allocation, so each failure leaks one nlm_file.
Route the failure through out_free so kfree() runs before the
function returns. |
| In the Linux kernel, the following vulnerability has been resolved:
lockd: Plug nlm_file refcount leak on cached nlm_do_fopen() failure
The cached-file path in nlm_lookup_file() reaches the found: label
unconditionally, even when nlm_do_fopen() fails. At that label
*result and file->f_count are updated before the error is returned.
The wrappers nlm3svc_lookup_file() and nlm4svc_lookup_file() then
bail out of their switch without copying *result back to their
caller, so the proc handler's local nlm_file pointer remains NULL
and the cleanup path skips nlm_release_file(). The f_count
increment is never released, and nlm_traverse_files() can no
longer reap the file because its refcount never returns to zero
between requests.
Short-circuit the cached path so neither *result nor f_count is
touched when nlm_do_fopen() fails on a hashed nlm_file. |
| In the Linux kernel, the following vulnerability has been resolved:
SUNRPC: Bound-check xdr_buf_to_bvec() stores before writing
xdr_buf_to_bvec() writes a bio_vec into the caller's array before
testing whether that slot is in range, and the head branch performs
the store with no check at all. When the caller's budget is exactly
used up, the next store lands one element past the end of the array.
The overflow label returns count - 1, which masks the surplus store
but cannot undo it.
rq_bvec, the array passed by nfsd_vfs_write(), is allocated to
exactly rq_maxpages entries with no slack. The OOB store can land in
adjacent slab memory; the bv_len and bv_offset fields written there
are derived from client-supplied RPC payload sizes.
Move the in-range check ahead of the store in the head, page-loop,
and tail branches. With the check at the top of each sequence, count
is incremented only after a successful store, so the overflow label
can return count directly. |
| In the Linux kernel, the following vulnerability has been resolved:
MIPS: DEC: Ensure 32-bit stack location for o32 prom_printf()
In 64-bit configurations calling any firmware entry points from a kernel
thread other than the initial one will result in a situation where the
stack has been placed in the XKPHYS 64-bit memory segment.
Consequently the stack pointer is no longer a 32-bit value and when the
32-bit firmware code called uses 32-bit ALU operations to manipulate the
stack pointer, the calculated result is incorrect (in fact in the 64-bit
MIPS ISA almost all 32-bit ALU operations will produce an unpredictable
result when executed on 64-bit data) and control goes astray.
This may happen when no final console driver has been enabled in the
configuration and consequently the initial console continues being used
late into bootstrap, or with an upcoming change that will switch the zs
driver to use a platform device, which in turn will make the console
handover happen only after other kernel threads have already been
started, and the kernel will hang at:
pid_max: default: 32768 minimum: 301
or somewhat later, but always before:
cblist_init_generic: Setting adjustable number of callback queues.
has been printed.
It seems that only the prom_printf() entry point is affected. Of all
the other entry points wired only rex_slot_address() and rex_gettcinfo()
are called from a kernel thread other than the initial one, specifically
kernel_init(), and they are leaf functions that do no business with the
stack, having worked with no issue ever since 64-bit support was added
for the platform back in 2002.
To address this issue then, arrange for the stack to be switched in the
o32 wrapper as required for prom_printf() only, by supplying call_o32()
with a pointer to a chunk of initdata space, which is placed in the
CKSEG0 32-bit compatibility segment, observing that prom_printf() is
only called from console output handler and therefore with the console
lock held, implying no need for this code to be reentrant.
Other firmware entry points may be called with interrupts enabled and no
lock held, and may therefore require that call_o32() be reentrant. They
trigger no issue at this point and "if it ain't broke, don't fix it," so
just leave them alone. |
