| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| In the Linux kernel, the following vulnerability has been resolved:
mm/hugetlb.c: fix UAF of vma in hugetlb fault pathway
Syzbot reports a UAF in hugetlb_fault(). This happens because
vmf_anon_prepare() could drop the per-VMA lock and allow the current VMA
to be freed before hugetlb_vma_unlock_read() is called.
We can fix this by using a modified version of vmf_anon_prepare() that
doesn't release the VMA lock on failure, and then release it ourselves
after hugetlb_vma_unlock_read(). |
| In the Linux kernel, the following vulnerability has been resolved:
bpf: Fix use-after-free in bpf_uprobe_multi_link_attach()
If bpf_link_prime() fails, bpf_uprobe_multi_link_attach() goes to the
error_free label and frees the array of bpf_uprobe's without calling
bpf_uprobe_unregister().
This leaks bpf_uprobe->uprobe and worse, this frees bpf_uprobe->consumer
without removing it from the uprobe->consumers list. |
| In the Linux kernel, the following vulnerability has been resolved:
spi: hisi-kunpeng: Add verification for the max_frequency provided by the firmware
If the value of max_speed_hz is 0, it may cause a division by zero
error in hisi_calc_effective_speed().
The value of max_speed_hz is provided by firmware.
Firmware is generally considered as a trusted domain. However, as
division by zero errors can cause system failure, for defense measure,
the value of max_speed is validated here. So 0 is regarded as invalid
and an error code is returned. |
| In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: btintel_pcie: Allocate memory for driver private data
Fix driver not allocating memory for struct btintel_data which is used
to store internal data. |
| In the Linux kernel, the following vulnerability has been resolved:
firmware: qcom: uefisecapp: Fix deadlock in qcuefi_acquire()
If the __qcuefi pointer is not set, then in the original code, we would
hold onto the lock. That means that if we tried to set it later, then
it would cause a deadlock. Drop the lock on the error path. That's
what all the callers are expecting. |
| In the Linux kernel, the following vulnerability has been resolved:
drm/xe/client: fix deadlock in show_meminfo()
There is a real deadlock as well as sleeping in atomic() bug in here, if
the bo put happens to be the last ref, since bo destruction wants to
grab the same spinlock and sleeping locks. Fix that by dropping the ref
using xe_bo_put_deferred(), and moving the final commit outside of the
lock. Dropping the lock around the put is tricky since the bo can go
out of scope and delete itself from the list, making it difficult to
navigate to the next list entry.
(cherry picked from commit 0083b8e6f11d7662283a267d4ce7c966812ffd8a) |
| In the Linux kernel, the following vulnerability has been resolved:
drm/xe/client: add missing bo locking in show_meminfo()
bo_meminfo() wants to inspect bo state like tt and the ttm resource,
however this state can change at any point leading to stuff like NPD and
UAF, if the bo lock is not held. Grab the bo lock when calling
bo_meminfo(), ensuring we drop any spinlocks first. In the case of
object_idr we now also need to hold a ref.
v2 (MattB)
- Also add xe_bo_assert_held()
(cherry picked from commit 4f63d712fa104c3ebefcb289d1e733e86d8698c7) |
| In the Linux kernel, the following vulnerability has been resolved:
x86/hyperv: fix kexec crash due to VP assist page corruption
commit 9636be85cc5b ("x86/hyperv: Fix hyperv_pcpu_input_arg handling when
CPUs go online/offline") introduces a new cpuhp state for hyperv
initialization.
cpuhp_setup_state() returns the state number if state is
CPUHP_AP_ONLINE_DYN or CPUHP_BP_PREPARE_DYN and 0 for all other states.
For the hyperv case, since a new cpuhp state was introduced it would
return 0. However, in hv_machine_shutdown(), the cpuhp_remove_state() call
is conditioned upon "hyperv_init_cpuhp > 0". This will never be true and
so hv_cpu_die() won't be called on all CPUs. This means the VP assist page
won't be reset. When the kexec kernel tries to setup the VP assist page
again, the hypervisor corrupts the memory region of the old VP assist page
causing a panic in case the kexec kernel is using that memory elsewhere.
This was originally fixed in commit dfe94d4086e4 ("x86/hyperv: Fix kexec
panic/hang issues").
Get rid of hyperv_init_cpuhp entirely since we are no longer using a
dynamic cpuhp state and use CPUHP_AP_HYPERV_ONLINE directly with
cpuhp_remove_state(). |
| In the Linux kernel, the following vulnerability has been resolved:
ASoC: Intel: soc-acpi-intel-lnl-match: add missing empty item
There is no links_num in struct snd_soc_acpi_mach {}, and we test
!link->num_adr as a condition to end the loop in hda_sdw_machine_select().
So an empty item in struct snd_soc_acpi_link_adr array is required. |
| In the Linux kernel, the following vulnerability has been resolved:
ASoC: Intel: soc-acpi-intel-mtl-match: add missing empty item
There is no links_num in struct snd_soc_acpi_mach {}, and we test
!link->num_adr as a condition to end the loop in hda_sdw_machine_select().
So an empty item in struct snd_soc_acpi_link_adr array is required. |
| In the Linux kernel, the following vulnerability has been resolved:
usbnet: ipheth: do not stop RX on failing RX callback
RX callbacks can fail for multiple reasons:
* Payload too short
* Payload formatted incorrecly (e.g. bad NCM framing)
* Lack of memory
None of these should cause the driver to seize up.
Make such failures non-critical and continue processing further
incoming URBs. |
| In the Linux kernel, the following vulnerability has been resolved:
wifi: mt76: mt7921: fix NULL pointer access in mt7921_ipv6_addr_change
When disabling wifi mt7921_ipv6_addr_change() is called as a notifier.
At this point mvif->phy is already NULL so we cannot use it here. |
| In the Linux kernel, the following vulnerability has been resolved:
net: phy: dp83822: Fix NULL pointer dereference on DP83825 devices
The probe() function is only used for DP83822 and DP83826 PHY,
leaving the private data pointer uninitialized for the DP83825 models
which causes a NULL pointer dereference in the recently introduced/changed
functions dp8382x_config_init() and dp83822_set_wol().
Add the dp8382x_probe() function, so all PHY models will have a valid
private data pointer to fix this issue and also prevent similar issues
in the future. |
| In the Linux kernel, the following vulnerability has been resolved:
drm/amd/display: Avoid race between dcn10_set_drr() and dc_state_destruct()
dc_state_destruct() nulls the resource context of the DC state. The pipe
context passed to dcn10_set_drr() is a member of this resource context.
If dc_state_destruct() is called parallel to the IRQ processing (which
calls dcn10_set_drr() at some point), we can end up using already nulled
function callback fields of struct stream_resource.
The logic in dcn10_set_drr() already tries to avoid this, by checking tg
against NULL. But if the nulling happens exactly after the NULL check and
before the next access, then we get a race.
Avoid this by copying tg first to a local variable, and then use this
variable for all the operations. This should work, as long as nobody
frees the resource pool where the timing generators live.
(cherry picked from commit a3cc326a43bdc48fbdf53443e1027a03e309b643) |
| In the Linux kernel, the following vulnerability has been resolved:
drm/amd/display: Avoid race between dcn35_set_drr() and dc_state_destruct()
dc_state_destruct() nulls the resource context of the DC state. The pipe
context passed to dcn35_set_drr() is a member of this resource context.
If dc_state_destruct() is called parallel to the IRQ processing (which
calls dcn35_set_drr() at some point), we can end up using already nulled
function callback fields of struct stream_resource.
The logic in dcn35_set_drr() already tries to avoid this, by checking tg
against NULL. But if the nulling happens exactly after the NULL check and
before the next access, then we get a race.
Avoid this by copying tg first to a local variable, and then use this
variable for all the operations. This should work, as long as nobody
frees the resource pool where the timing generators live.
(cherry picked from commit 0607a50c004798a96e62c089a4c34c220179dcb5) |
| In the Linux kernel, the following vulnerability has been resolved:
tracing/timerlat: Only clear timer if a kthread exists
The timerlat tracer can use user space threads to check for osnoise and
timer latency. If the program using this is killed via a SIGTERM, the
threads are shutdown one at a time and another tracing instance can start
up resetting the threads before they are fully closed. That causes the
hrtimer assigned to the kthread to be shutdown and freed twice when the
dying thread finally closes the file descriptors, causing a use-after-free
bug.
Only cancel the hrtimer if the associated thread is still around. Also add
the interface_lock around the resetting of the tlat_var->kthread.
Note, this is just a quick fix that can be backported to stable. A real
fix is to have a better synchronization between the shutdown of old
threads and the starting of new ones. |
| In the Linux kernel, the following vulnerability has been resolved:
userfaultfd: don't BUG_ON() if khugepaged yanks our page table
Since khugepaged was changed to allow retracting page tables in file
mappings without holding the mmap lock, these BUG_ON()s are wrong - get
rid of them.
We could also remove the preceding "if (unlikely(...))" block, but then we
could reach pte_offset_map_lock() with transhuge pages not just for file
mappings but also for anonymous mappings - which would probably be fine
but I think is not necessarily expected. |
| In the Linux kernel, the following vulnerability has been resolved:
drm/panthor: Restrict high priorities on group_create
We were allowing any users to create a high priority group without any
permission checks. As a result, this was allowing possible denial of
service.
We now only allow the DRM master or users with the CAP_SYS_NICE
capability to set higher priorities than PANTHOR_GROUP_PRIORITY_MEDIUM.
As the sole user of that uAPI lives in Mesa and hardcode a value of
MEDIUM [1], this should be safe to do.
Additionally, as those checks are performed at the ioctl level,
panthor_group_create now only check for priority level validity.
[1]https://gitlab.freedesktop.org/mesa/mesa/-/blob/f390835074bdf162a63deb0311d1a6de527f9f89/src/gallium/drivers/panfrost/pan_csf.c#L1038 |
| In the Linux kernel, the following vulnerability has been resolved:
net: hns3: void array out of bound when loop tnl_num
When query reg inf of SSU, it loops tnl_num times. However, tnl_num comes
from hardware and the length of array is a fixed value. To void array out
of bound, make sure the loop time is not greater than the length of array |
| In the Linux kernel, the following vulnerability has been resolved:
net: microchip: vcap: Fix use-after-free error in kunit test
This is a clear use-after-free error. We remove it, and rely on checking
the return code of vcap_del_rule. |
