| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| A vulnerability in the web-based management interface of Cisco HyperFlex Software could allow an unauthenticated, remote attacker to conduct a cross-site request forgery (CSRF) attack on an affected system. The vulnerability is due to insufficient CSRF protections for the web UI on an affected device. An attacker could exploit this vulnerability by persuading a user of the interface to follow a malicious link. A successful exploit could allow the attacker to perform arbitrary actions with the privilege level of the affected user. |
| A vulnerability in the web-based management interface of Cisco Integrated Management Controller (IMC) Software could allow an authenticated, remote attacker to make unauthorized changes to the system configuration. The vulnerability is due to insufficient authorization enforcement. An attacker could exploit this vulnerability by sending a crafted HTTP request to the affected software. A successful exploit could allow a user with read-only privileges to change critical system configurations using administrator privileges. |
| A vulnerability in the Virtual Shell (VSH) session management for Cisco NX-OS Software could allow an authenticated, remote attacker to cause a VSH process to fail to delete upon termination. This can lead to a build-up of VSH processes that overtime can deplete system memory. When there is no system memory available, this can cause unexpected system behaviors and crashes. The vulnerability is due to the VSH process not being properly deleted when a remote management connection to the device is disconnected. An attacker could exploit this vulnerability by repeatedly performing a remote management connection to the device and terminating the connection in an unexpected manner. A successful exploit could allow the attacker to cause the VSH processes to fail to delete, which can lead to a system-wide denial of service (DoS) condition. The attacker must have valid user credentials to log in to the device using the remote management connection. |
| lilishop <=4.2.4 is vulnerable to Incorrect Access Control, which can allow attackers to obtain coupons beyond the quantity limit by capturing and sending the data packets for coupon collection in high concurrency. |
| Multiple vulnerabilities in the web-based user interface (Web UI) of Cisco IOS XE Software could allow an authenticated, remote attacker to execute commands with elevated privileges on the affected device. For more information about these vulnerabilities, see the Details section of this advisory. |
| Multiple vulnerabilities in the web-based user interface (Web UI) of Cisco IOS XE Software could allow an authenticated, remote attacker to execute commands with elevated privileges on the affected device. For more information about these vulnerabilities, see the Details section of this advisory. |
| A vulnerability in the Cisco TrustSec (CTS) Protected Access Credential (PAC) provisioning module of Cisco IOS XE Software could allow an unauthenticated, remote attacker to cause a reload of an affected device, resulting in a denial of service (DoS) condition. The vulnerability is due to improper validation of attributes in RADIUS messages. An attacker could exploit this vulnerability by sending a malicious RADIUS message to an affected device while the device is in a specific state. |
| A vulnerability in the HTTP client feature of Cisco IOS and IOS XE Software could allow an unauthenticated, remote attacker to read and modify data that should normally have been sent via an encrypted channel. The vulnerability is due to TCP port information not being considered when matching new requests to existing, persistent HTTP connections. An attacker could exploit this vulnerability by acting as a man-in-the-middle and then reading and/or modifying data that should normally have been sent through an encrypted channel. |
| A vulnerability in the RADIUS Change of Authorization (CoA) code of Cisco TrustSec, a feature within Cisco IOS XE Software, could allow an unauthenticated, remote attacker to cause a denial of service (DoS) condition on an affected device. The vulnerability is due to improper handling of a malformed packet. An attacker could exploit this vulnerability by sending a malformed packet to an affected device. A successful exploit could allow the attacker to cause a DoS condition on the affected device. |
| A vulnerability in the Dialer interface feature for ISDN connections in Cisco IOS XE Software for Cisco 4000 Series Integrated Services Routers (ISRs) could allow an unauthenticated, adjacent attacker to pass IPv4 traffic through an ISDN channel prior to successful PPP authentication. The vulnerability is due to insufficient validation of the state of the PPP IP Control Protocol (IPCP). An attacker could exploit this vulnerability by making an ISDN call to an affected device and sending traffic through the ISDN channel prior to successful PPP authentication. Alternatively, an unauthenticated, remote attacker could exploit this vulnerability by sending traffic through an affected device that is configured to exit via an ISDN connection for which both the Dialer interface and the Basic Rate Interface (BRI) have been configured, but the Challenge Handshake Authentication Protocol (CHAP) password for PPP does not match the remote end. A successful exploit could allow the attacker to pass IPv4 traffic through an unauthenticated ISDN connection for a few seconds, from initial ISDN call setup until PPP authentication fails. |
| A vulnerability in the web-based management interface of Cisco Small Business Smart and Managed Switches could allow an unauthenticated, remote attacker to conduct a cross-site request forgery (CSRF) attack on an affected system. The vulnerability is due to insufficient CSRF protections for the web-based management interface on an affected device. An attacker could exploit this vulnerability by persuading a user of the interface to follow a malicious link. A successful exploit could allow the attacker to perform arbitrary actions with the privilege level of the targeted user. If the user has administrative privileges, the attacker could alter the configuration, execute commands, or cause a denial of service (DoS) condition on an affected device. |
| A vulnerability in the web application of Cisco TelePresence Advanced Media Gateway could allow an authenticated, remote attacker to cause a denial of service (DoS) condition on an affected device. The vulnerability is due to the lack of input validation in the web application. An attacker could exploit this vulnerability by sending a crafted authenticated HTTP request to the device. An exploit could allow the attacker to stop services on an affected device. The device may become inoperable and results in a denial of service (DoS) condition. |
| A vulnerability in the web-based management interface of Cisco Unified Communications Manager could allow an authenticated, remote attacker to conduct SQL injection attacks on an affected system. The vulnerability exists because the web-based management interface improperly validates SQL values. An attacker could exploit this vulnerability by authenticating to the application and sending malicious requests to an affected system. A successful exploit could allow the attacker to modify values on or return values from the underlying database. |
| Facsimile Support for IBM i 7.2, 7.3, 7.4, and 7.5 could allow a local user to gain elevated privileges due to an unqualified library call. A malicious actor could cause arbitrary code to run with the privilege of the user invoking the facsimile support. IBM X-Force ID: 267689. |
| IBM Security Guardium 11.3, 11.4, and 11.5 is potentially vulnerable to CSV injection. A remote attacker could execute malicious commands due to improper validation of csv file contents. IBM X-Force ID: 265262. |
| IBM InfoSphere Information Server 11.7 could allow an authenticated user to change installation files due to incorrect file permission settings. IBM X-Force ID: 263332. |
| Stored Cross-Site Scripting (XSS) vulnerability in Snipe-IT - v7.0.13 allows an attacker to upload a malicious XML file containing JavaScript code. This can lead to privilege escalation when the payload is executed, granting the attacker super admin permissions within the Snipe-IT system. |
| Tenda G3 v3.0 v15.11.0.20 was discovered to contain a command injection vulnerability via the formSetDebugCfg function. |
| Tenda G3 v3.0 v15.11.0.20 was discovered to contain a command injection vulnerability via the formSetUSBPartitionUmount function. |
| A vulnerability has been discovered in Bitdefender Total Security HTTPS scanning functionality that results in the improper trust of certificates issued using the DSA signature algorithm. The product does not properly check the certificate chain, allowing an attacker to establish MITM SSL connections to arbitrary sites using a DSA-signed certificate. |
