| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| A vulnerability in the implementation of SAML 2.0 single sign-on (SSO) for remote access VPN services in Cisco Adaptive Security Appliance (ASA) Software and Cisco Firepower Threat Defense (FTD) Software could allow an authenticated, remote attacker to successfully establish a VPN session on an affected device. This vulnerability is due to improper separation of authorization domains when using SAML authentication. An attacker could exploit this vulnerability by using valid credentials to successfully authenticate using their designated connection profile (tunnel group), intercepting the SAML SSO token that is sent back from the Cisco ASA device, and then submitting the same SAML SSO token to a different tunnel group for authentication. A successful exploit could allow the attacker to establish a remote access VPN session using a connection profile that they are not authorized to use and connect to secured networks behind the affected device that they are not authorized to access. For successful exploitation, the attacker must have valid remote access VPN user credentials. |
| A vulnerability in the FTP inspection engine of Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to cause an affected device to reload, resulting in a denial of service (DoS) condition. The vulnerability exists because the affected software fails to release spinlocks when a device is running low on system memory, if the software is configured to apply FTP inspection and an access control rule to transit traffic, and the access control rule is associated with an FTP file policy. An attacker could exploit this vulnerability by sending a high rate of transit traffic through an affected device to cause a low-memory condition on the device. A successful exploit could allow the attacker to cause a software panic on the affected device, which could cause the device to reload and result in a temporary DoS condition. |
| Multiple Cisco products are affected by a vulnerability in the Snort detection engine that could allow an unauthenticated, remote attacker to bypass a configured File Policy for HTTP. The vulnerability is due to incorrect detection of modified HTTP packets used in chunked responses. An attacker could exploit this vulnerability by sending crafted HTTP packets through an affected device. A successful exploit could allow the attacker to bypass a configured File Policy for HTTP packets and deliver a malicious payload. |
| A vulnerability in the web services interface of Cisco Adaptive Security Appliance (ASA) Software and Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to conduct directory traversal attacks and read sensitive files on a targeted system. The vulnerability is due to a lack of proper input validation of URLs in HTTP requests processed by an affected device. An attacker could exploit this vulnerability by sending a crafted HTTP request containing directory traversal character sequences to an affected device. A successful exploit could allow the attacker to view arbitrary files within the web services file system on the targeted device. The web services file system is enabled when the affected device is configured with either WebVPN or AnyConnect features. This vulnerability cannot be used to obtain access to ASA or FTD system files or underlying operating system (OS) files. |
| Multiple vulnerabilities in Cisco Adaptive Security Appliance (ASA) Software and Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to cause a denial of service (DoS) condition on an affected device. These vulnerabilities are due to lack of proper input validation of the HTTPS request. An attacker could exploit these vulnerabilities by sending a crafted HTTPS request to an affected device. A successful exploit could allow the attacker to cause the affected device to reload, resulting in a DoS condition. Note: This vulnerability affects only specific AnyConnect and WebVPN configurations. For more information, see the Vulnerable Products section. |
| Apache Log4j2 2.0-beta9 through 2.15.0 (excluding security releases 2.12.2, 2.12.3, and 2.3.1) JNDI features used in configuration, log messages, and parameters do not protect against attacker controlled LDAP and other JNDI related endpoints. An attacker who can control log messages or log message parameters can execute arbitrary code loaded from LDAP servers when message lookup substitution is enabled. From log4j 2.15.0, this behavior has been disabled by default. From version 2.16.0 (along with 2.12.2, 2.12.3, and 2.3.1), this functionality has been completely removed. Note that this vulnerability is specific to log4j-core and does not affect log4net, log4cxx, or other Apache Logging Services projects. |
| A vulnerability in the hardware-based SSL/TLS cryptography functionality of Cisco Adaptive Security Appliance (ASA) Software and Cisco Firepower Threat Defense (FTD) Software for Cisco Firepower 2100 Series Appliances could allow an unauthenticated, remote attacker to cause an affected device to reload unexpectedly, resulting in a denial of service (DoS) condition.
This vulnerability is due to an implementation error within the cryptographic functions for SSL/TLS traffic processing when they are offloaded to the hardware. An attacker could exploit this vulnerability by sending a crafted stream of SSL/TLS traffic to an affected device. A successful exploit could allow the attacker to cause an unexpected error in the hardware-based cryptography engine, which could cause the device to reload. |
| A vulnerability in the SSL/TLS certificate handling of Snort 3 Detection Engine integration with Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to cause the Snort 3 detection engine to restart. This vulnerability is due to a logic error that occurs when an SSL/TLS certificate that is under load is accessed when it is initiating an SSL connection. Under specific, time-based constraints, an attacker could exploit this vulnerability by sending a high rate of SSL/TLS connection requests to be inspected by the Snort 3 detection engine on an affected device. A successful exploit could allow the attacker to cause the Snort 3 detection engine to reload, resulting in either a bypass or a denial of service (DoS) condition, depending on device configuration. The Snort detection engine will restart automatically. No manual intervention is required. |
| A vulnerability in the Simple Network Management Protocol (SNMP) feature of Cisco Adaptive Security Appliance (ASA) Software and Cisco Firepower Threat Defense (FTD) Software could allow an authenticated, remote attacker to cause an unexpected reload of the device.
This vulnerability is due to insufficient input validation of SNMP packets. An attacker could exploit this vulnerability by sending a crafted SNMP request to an affected device using IPv4 or IPv6. A successful exploit could allow the attacker to cause the affected device to reload, resulting in a denial of service (DoS) condition. This vulnerability affects all versions of SNMP (versions 1, 2c, and 3) and requires a valid SNMP community string or valid SNMPv3 user credentials. |
| A vulnerability in the activation of an access control list (ACL) on Cisco Adaptive Security Appliance (ASA) Software and Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to bypass the protection that is offered by a configured ACL on an affected device. This vulnerability is due to a logic error that occurs when an ACL changes from inactive to active in the running configuration of an affected device. An attacker could exploit this vulnerability by sending traffic through the affected device that should be denied by the configured ACL. The reverse condition is also true—traffic that should be permitted could be denied by the configured ACL. A successful exploit could allow the attacker to bypass configured ACL protections on the affected device, allowing the attacker to access trusted networks that the device might be protecting. Note: This vulnerability applies to both IPv4 and IPv6 traffic as well as dual-stack ACL configurations in which both IPv4 and IPv6 ACLs are configured on an interface. |
| A vulnerability in the AnyConnect firewall for Cisco Adaptive Security Appliance (ASA) Software and Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to bypass a configured access control list (ACL) and allow traffic that should have been denied to flow through an affected device. This vulnerability is due to a logic error in populating group ACLs when an AnyConnect client establishes a new session toward an affected device. An attacker could exploit this vulnerability by establishing an AnyConnect connection to the affected device. A successful exploit could allow the attacker to bypass configured ACL rules. |
| A vulnerability in the Snort 2 and Snort 3 TCP and UDP detection engine of Cisco Firepower Threat Defense (FTD) Software for Cisco Firepower 2100 Series Appliances could allow an unauthenticated, remote attacker to cause memory corruption, which could cause the Snort detection engine to restart unexpectedly.
This vulnerability is due to improper memory management when the Snort detection engine processes specific TCP or UDP packets. An attacker could exploit this vulnerability by sending crafted TCP or UDP packets through a device that is inspecting traffic using the Snort detection engine. A successful exploit could allow the attacker to restart the Snort detection engine repeatedly, which could cause a denial of service (DoS) condition. The DoS condition impacts only the traffic through the device that is examined by the Snort detection engine. The device can still be managed over the network.
Note: Once a memory block is corrupted, it cannot be cleared until the Cisco Firepower 2100 Series Appliance is manually reloaded. This means that the Snort detection engine could crash repeatedly, causing traffic that is processed by the Snort detection engine to be dropped until the device is manually reloaded. |
| IBM Cognos Analytics 12.1.3 GA Version with build number through 12.1.3-2606251736 could allow an attacker to obtain incorrect report summary results or cause report-processing failures due to a race condition in the Agentic AI assistant's concurrent request-handling logic when multiple authenticated users submit report-related tasks simultaneously. |
| Acrobat Reader is affected by a Heap-based Buffer Overflow vulnerability that could result in arbitrary code execution in the context of the current user. Exploitation of this issue requires user interaction in that a victim must open a malicious file. |
| Improper neutralization of special elements used in an os command ('os command injection') in GitHub Copilot and Visual Studio Code allows an unauthorized attacker to elevate privileges locally. |
| In Eclipse OpenJ9 versions up to 0.60, using -Xtrace to trace method arguments can lead to buffer underflow. |
| In the Linux kernel, the following vulnerability has been resolved:
net: qualcomm: rmnet: fix endpoint use-after-free in rmnet_dellink()
rmnet_dellink() removes the endpoint from the hash table with
hlist_del_init_rcu() and then immediately frees it with kfree(). However,
RCU readers on the receive path (rmnet_rx_handler ->
__rmnet_map_ingress_handler) may still hold a reference to the endpoint and
dereference ep->egress_dev after the memory has been freed. The endpoint is
a kmalloc-32 object, and the stale read at offset 8 corresponds to the
egress_dev pointer.
BUG: unable to handle page fault for address: ffffffffde942eef
Oops: 0002 [#1] SMP NOPTI
CPU: 1 UID: 0 PID: 137 Comm: poc_write Not tainted 7.0.0+ #4 PREEMPTLAZY
RIP: 0010:rmnet_vnd_rx_fixup (rmnet_vnd.c:27)
Call Trace:
<TASK>
__rmnet_map_ingress_handler (rmnet_handlers.c:48 rmnet_handlers.c:101)
rmnet_rx_handler (rmnet_handlers.c:129 rmnet_handlers.c:235)
__netif_receive_skb_core.constprop.0 (net/core/dev.c:6096)
__netif_receive_skb_one_core (net/core/dev.c:6208)
netif_receive_skb (net/core/dev.c:6467)
tun_get_user (drivers/net/tun.c:1955)
tun_chr_write_iter (drivers/net/tun.c:2003)
vfs_write (fs/read_write.c:688)
ksys_write (fs/read_write.c:740)
</TASK>
Add an rcu_head field to struct rmnet_endpoint and replace kfree() with
kfree_rcu() so the endpoint memory remains valid through the RCU grace
period. Also remove the rmnet_vnd_dellink() call and inline only the
nr_rmnet_devs decrement, since rmnet_vnd_dellink() would set
ep->egress_dev to NULL during the grace period, creating a data race
with lockless readers. |
| In Eclipse OMR versions up to 0.11, the arraycmp SIMD implementation for Z and P does not check if the number of bytes to compare is zero. |
| In Eclipse hawkBit versions 1.0.3 and prior, a privilege escalation vulnerability (CWE-284 / CWE-862) has been identified in the Direct Device Integration (DDI) Controller.
This vulnerability allows an authenticated device to escalate its permissions and bypass the strict boundaries of its assigned updates. Under normal operation, a device should be restricted strictly to the specific firmware artifacts explicitly assigned to it. However, this flaw enables any authenticated device to bypass this restriction and download any firmware artifact within the same tenant.
This is not an authentication bypass; the requesting device must possess valid credentials for its respective tenant. Instead, the issue stems from a flaw in object-level authorization validation.
A related, lower-severity helper issue exists in the listing software modules artifacts metadata endpoint. This endpoint does not enforce assignment checks, enabling an authenticated device to list and enumerate available firmware artifacts, which can facilitate targeted exfiltration using the main download authorization bypass. |
| Heap type confusion and out-of-bounds read/write in the Apache Fory C++ implementation. When deserializing data in compatible mode, the field-skip paths do not correctly validate the declared field types against the actual data, so input with an inconsistent schema can cause type confusion and out-of-bounds memory access. Only the C++ implementation is affected; other language implementations of Apache Fory are not.
This issue affects Apache Fory C++: from 0.14.0 before 1.4.0.
Users are recommended to upgrade to version 1.4.0, which fixes the issue. |
