| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| In the Linux kernel, the following vulnerability has been resolved:
crypto: marvell/octeontx - fix DMA cleanup using wrong loop index
The sg_cleanup path used list[i] instead of list[j] when unmapping DMA
buffers, leaking successfully mapped entries and repeatedly unmapping
the failed one. |
| In the Linux kernel, the following vulnerability has been resolved:
ASoC: codecs: hdac_hdmi: Validate written enum value
hdac_hdmi_set_pin_port_mux() uses the written enum value to index the
texts array before calling snd_soc_dapm_put_enum_double(), which validates
that the value is within the enum item range.
An out-of-range value can therefore make the driver read past the texts
array before the helper rejects the write. Move the lookup after the helper
has accepted the value. |
| In the Linux kernel, the following vulnerability has been resolved:
RDMA/mlx5: Fix undefined shift of user RQ WQE size
set_rq_size() computes the RQ WQE size as "1 << rq_wqe_shift" based on
the user-provided rq_wqe_shift, which is only checked to be greater than
32, so shifts of 32 are still accepted. A shift of 31 also overflows a
signed integer, leading to undefined behavior.
Use check_shl_overflow() to compute the RQ WQE size and reject any
invalid values. |
| In the Linux kernel, the following vulnerability has been resolved:
ASoC: tegra: tegra210_ahub: Validate written enum value
tegra_ahub_put_value_enum() reads e->values[item[0]] before
checking whether item[0] is within the enum item range. The existing
check therefore happens too late to prevent an out-of-range read of the
values array.
Move the check before the array access. |
| In the Linux kernel, the following vulnerability has been resolved:
vdpa/octeon_ep: fix IRQ-to-ring mapping in interrupt handler
Look up the IRQ index in oct_hw->irqs instead of assuming
irq - irqs[0]. This supports non-contiguous IRQ numbers and
avoids incorrect ring indexing when irqs[0] is not the base. |
| In the Linux kernel, the following vulnerability has been resolved:
ext4: fix fast commit wait/wake bit mapping on 64-bit
On 64-bit, ext4 dynamic inode states live in the upper half of i_flags,
and ext4_test_inode_state() applies the corresponding +32 offset.
The fast-commit wait and wake paths open-coded the wait key with the raw
EXT4_STATE_* value. Add small helpers for the state wait word and bit,
and use them for the FC_COMMITTING and FC_FLUSHING_DATA waits so the wait
key follows the same mapping as the state helpers. |
| In the Linux kernel, the following vulnerability has been resolved:
RDMA/irdma: Fix OOB read during CQ MR registration
Sashiko pointed out an unrelated bug during a previous patch:
https://sashiko.dev/#/patchset/20260512183852.614045-1-jmoroni%40google.com
This change fixes the bug by eliminating the cqmr->split field which
was not being set properly and instead just checks the CQ resize
feature flag directly.
The cqmr->split field essentially tracks whether IRDMA_FEATURE_CQ_RESIZE
is set, but it was not being set until CQ creation time, which is _after_
CQ memory registration (the only other place where it is referenced).
As a result, it would always be false during MR registration and would
therefore cause irdma_handle_q_mem to populate cqmr->shadow even for GEN_2
HW and beyond:
cqmr->shadow = (dma_addr_t)arr[req->cq_pages];
The issue is that for GEN_2 and beyond, req->cq_pages may be exactly equal
to iwmr->page_cnt and therefore equal to the size of arr, which would cause
an OOB read by one. |
| In the Linux kernel, the following vulnerability has been resolved:
nvme: fix FDP fdpcidx bounds check
The fdpcidx bounds check sets n = NUMFDPC + 1 but used > instead of >=,
incorrectly accepting fdp_idx when it equals n (i.e. NUMFDPC + 1). |
| In the Linux kernel, the following vulnerability has been resolved:
fbdev: sm501fb: Fix buffer errors in OF binding code
The code that gets the frame buffer mode from OF has 'use after free',
'buffer overrun' and memory leaks.
info->edid_data isn't free if the probe functions fail or if
pd->def_mode is set.
If both the CRT and PANEL are enabled info->edid_data is used after
being freed and is freed twice.
The string returned by of_get_property(np, "mode", &len) is just
written over either the static "640x480-16@60" or the module parameter
string without any regard for the length (which is most likely longer).
Use kstrump() for the OF mode and free everything before freeing 'info. |
| In the Linux kernel, the following vulnerability has been resolved:
evm: terminate and bound the evm_xattrs read buffer
evm_read_xattrs() allocates size + 1 bytes, fills them from the list of
enabled xattrs, and then passes strlen(temp) to
simple_read_from_buffer(). When no configured xattrs are enabled, the
fill loop stores nothing and temp[0] remains uninitialized, so strlen()
reads beyond initialized memory.
Explicitly terminate the buffer after allocation, use snprintf() for
each formatted line, and pass the accumulated length, without risk of
truncation, to simple_read_from_buffer(). |
| In the Linux kernel, the following vulnerability has been resolved:
tracing: Bound synthetic-field strings with seq_buf
The synthetic field helpers build a prefixed synthetic variable name and
a generated hist command in fixed MAX_FILTER_STR_VAL buffers. The
current code appends those strings with raw strcat(), so long key lists,
field names, or saved filters can run past the end of the staging
buffers.
Build both strings with seq_buf and propagate -E2BIG if either the
synthetic variable name or the generated command exceeds
MAX_FILTER_STR_VAL. This keeps the existing tracing-side limit while
using the helper intended for bounded command construction.
[ sdr: Moved struct seq_buf *s for upside-down x-mas tree formatting ] |
| In the Linux kernel, the following vulnerability has been resolved:
dm: limit target bio polling to one shot
dm_poll_bio() is the ->poll_bio() callback for a stacked dm device.
The caller only knows about the dm queue, so it may decide to do a
spinning poll if it thinks a single queue is being polled. Passing those
flags unchanged to the mapped clone lets blk_mq_poll() spin on a target
queue from inside dm_poll_bio().
With io_uring IOPOLL on a dm-stripe target this can keep a task in
dm_poll_bio() -> bio_poll() -> blk_mq_poll()
long enough to trigger an RCU CPU stall, before io_uring gets back to
io_iopoll_check() and its need_resched() check.
Keep dm's ->poll_bio() bounded by forcing one-shot polling for target
bios. The caller can invoke dm_poll_bio() again if it wants to keep
polling, and it also gets a chance to reap completions or reschedule
between passes. |
| In the Linux kernel, the following vulnerability has been resolved:
accel/amdxdna: Adjust size for copy_to_user()
The amount of data returned to user space should be limited by the buffer
size provided by the application. If the buffer is smaller than the data
size, return only the portion that fits instead of failing. |
| CSV export functionality in Brainstorm Force SureForms version, <= 2.12.1, fails to neutralize spreadsheet formula characters in user-controlled form field names before generating CSV exports, which allows a remote attacker to execute spreadsheet formulas on an administrator's workstation when the exported CSV file is opened in a vulnerable spreadsheet application. |
| A security flaw has been discovered in Comfast CF-N1-S 2.6.0.1. Affected by this issue is the function sub_44B438 of the file /cgi-bin/mbox-config?method=SET§ion=ptest_ssid of the component SSID Configuration. The manipulation of the argument ssid results in stack-based buffer overflow. The attack can be executed remotely. The exploit has been released to the public and may be used for attacks. |
| A weakness has been identified in UTT HiPER 1200GW up to 2.5.3-170306. Affected is the function strcpy of the file /goform/formGroupConfig. Executing a manipulation of the argument timestart can lead to stack-based buffer overflow. The attack may be performed from remote. The exploit has been made available to the public and could be used for attacks. |
| A vulnerability was found in xianrendzw EasyReport up to 2.0.17.0522_Beta. Affected is the function execSqlText/previewSqlText of the file DesignerController.java of the component SQL Preview Endpoint. The manipulation of the argument sqlText results in improper neutralization of special elements used in a template engine. The attack can be executed remotely. The exploit has been made public and could be used. The project was informed of the problem early through an issue report but has not responded yet. |
| Orval generates type-safe JavaScript clients in TypeScript from OpenAPI v3 and Swagger v2 specifications. Prior to 8.21.0, a ${...} expression or backtick in a header parameter default is emitted into a module-level template literal emitted by zod schema generation without safe encoding. This permits attacker-controlled JavaScript to be evaluated when the generated zod schema module is imported, resulting in code execution in the developer, CI, test, or application environment. The affected code is packages/zod/src/index.ts function formatDefaultValue. This issue is fixed in version 8.21.0. |
| Orval generates type-safe JavaScript clients in TypeScript from OpenAPI v3 and Swagger v2 specifications. Prior to 8.21.0, a double quote in a query parameter name is emitted into the generated request-validation zod.object({...}) schema without safe encoding. This permits attacker-controlled JavaScript to be evaluated when the generated zod schema module is imported, resulting in code execution in the developer, CI, test, or application environment. The affected code is packages/zod/src/index.ts and query request-validation generation. This issue is fixed in version 8.21.0. |
| libvips is a fast image processing library with low memory needs. Prior to version 8.18.3, libvips built with libultrahdr support can incorrectly size an output buffer in libvips/foreign/uhdrsave.c within vips_foreign_save_uhdr_set_raw_hdr when a pipeline enlarges an incoming JPEG to a very large output before encoding a gain map through VipsForeignSaveUhdr. The undersized allocation can cause a heap buffer over-read that may disclose adjacent data or crash the process. This issue is fixed in version 8.18.3. |
