| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| Dell Wyse Management Suite (WMS), versions prior to 2605.0.2, contain a Missing Authentication for Critical Function vulnerability. An unauthenticated attacker with remote access could potentially exploit this vulnerability, leading to Information disclosure. |
| In the Linux kernel, the following vulnerability has been resolved:
net: thunderbolt: Fix frags[] overflow by bounding frame_count
tbnet_poll() assembles a multi-frame ThunderboltIP packet into one skb. The
first frame goes into the skb linear area and every further frame is added as
a page fragment.
skb_add_rx_frag(skb, skb_shinfo(skb)->nr_frags,
page, hdr_size, frame_size,
TBNET_RX_PAGE_SIZE - hdr_size);
A packet of frame_count frames therefore ends up with frame_count - 1
fragments. tbnet_check_frame() only bounds the peer supplied frame_count to
TBNET_RING_SIZE / 4 (64), which is far above MAX_SKB_FRAGS (17 by default). A
peer that sends a packet of 19 or more small frames pushes nr_frags past
MAX_SKB_FRAGS, so skb_add_rx_frag() writes past skb_shinfo()->frags[] and
corrupts memory after the shared info.
Tighten the start of packet bound to MAX_SKB_FRAGS + 1 so a packet can never
produce more fragments than frags[] can hold. This matches the recent skb
frags overflow fixes in other receive paths, for example f0813bcd2d9d ("net:
wwan: t7xx: fix potential skb->frags overflow in RX path") and 600dc40554dc
("net: usb: cdc-phonet: fix skb frags[] overflow in rx_complete()"). |
| In the Linux kernel, the following vulnerability has been resolved:
netfilter: flowtable: use dst in this direction when pushing IPIP header
When pushing the IPIP header, the route of the other direction is used
to calculate the headroom, use the route in this direction. Accessing
the other tuple to set the IP source and destination is fine because
this tuple does not provide such information to avoid storing redundant
information. However, this tuple already provides the dst for this
direction, this went unnoticed because this bug affects headroom and
iph->frag_off only at this stage. |
| In the Linux kernel, the following vulnerability has been resolved:
netfilter: nf_conntrack_sip: validate skb_dst() before accessing it
tc ingress and openvswitch do not guarantee routing information to be
available. These subsystems use the conntrack helper infrastructure, and
the SIP helper relies on the skb_dst() to be present if
sip_external_media is set to 1 (which is disabled by default as a module
parameter).
This effectively disables the sip_external_media toggle for these
subsystems without resulting in a crash. |
| In the Linux kernel, the following vulnerability has been resolved:
netfilter: nft_fib: reject fib expression on the netdev egress hook
A fib expression in a netdev egress base chain dereferences nft_in(pkt),
NULL on the transmit path, causing a NULL pointer dereference at eval.
nft_fib_validate() masks the hook with NF_INET_* values, but netdev hook
numbers are a separate enum that aliases them (NF_NETDEV_EGRESS ==
NF_INET_LOCAL_IN), so an egress chain passes validation and then faults.
Add nft_fib_netdev_validate() that limits each result/flag to the netdev
hook where the device it reads exists: the input-device cases (OIF,
OIFNAME, ADDRTYPE with F_IIF) to ingress, the output-device case (ADDRTYPE
with F_OIF) to egress, ADDRTYPE with no device flag to both. Also restrict
nft_fib_validate() to NFPROTO_IPV4/IPV6/INET so its NF_INET_* masks are
not applied to another family's hooks. |
| The flash_copy() system call is verified by z_vrfy_flash_copy() in drivers/flash/flash_util.c. On builds with CONFIG_USERSPACE enabled, this handler is the kernel-side trust boundary for a user-mode caller. Prior to the fix it validated only the output buffer (K_SYSCALL_MEMORY_WRITE) and passed the two struct device * arguments, src_dev and dst_dev, directly into the implementation without any object validation — unlike every sibling flash syscall, which guards its device pointer with K_SYSCALL_DRIVER_FLASH.
A user-mode thread fully controls the values of src_dev/dst_dev and the contents of its own address space. The implementation z_impl_flash_copy() dereferences these pointers and calls through their driver-API function tables (e.g. api->get_parameters(dst_dev), flash_read(src_dev, ...), flash_write(dst_dev, ...)). By supplying a pointer to a forged struct device whose api table contains attacker-chosen function pointers, an unprivileged thread can cause the kernel to call arbitrary code in supervisor mode; passing any arbitrary or invalid address otherwise yields a kernel crash or out-of-bounds read.
The result is a local privilege escalation out of the userspace sandbox (with kernel denial-of-service and information disclosure as lesser outcomes). The fix adds K_SYSCALL_DRIVER_FLASH(src_dev, read) and K_SYSCALL_DRIVER_FLASH(dst_dev, write) to z_vrfy_flash_copy(), which verify each device is a registered flash-driver kernel object the calling thread is permitted to use before any dereference, closing the path completely. |
| IBM Security Verify Access 10.0 through 10.0.9.2 and IBM Verify Identity Access 11.0 through 11.0.3 and IBM Verify Identity Access Container 11.0 through 11.0.3 contains a format string injection vulnerability in the management interface that allows attackers to cause denial of service and information disclosure by crafting a malicious HTTP request. |
| IBM Security Verify Access 10.0 through 10.0.9.2 and IBM Verify Identity Access 11.0 through 11.0.3 and IBM Verify Identity Access Container 11.0 through 11.0.3 and IBM Security Verify Access Container 10.0 through 10.0.9.2 Reverse Proxy in certain configurations is vulnerable to a denial of service attack. |
| The Zephyr ADIN2111/ADIN1110 10BASE-T1S/T1L Ethernet driver (drivers/ethernet/eth_adin2111.c) reassembles received Ethernet frames in OPEN Alliance (OA) SPI mode by copying device-supplied 64-byte data chunks into a fixed static buffer ctx->buf of size CONFIG_ETH_ADIN2111_BUFFER_SIZE (default 1524 bytes). In eth_adin2111_oa_data_read(), each valid chunk was memcpy'd into ctx->buf[ctx->scur] and the write cursor scur advanced, with no check that scur + len stayed within the buffer. The number of chunks (up to 255, from the BUFSTS RCA field) and the per-chunk length are taken entirely from the frame data received off the wire; the cursor is only reset on a start-of-frame chunk. An attacker on the single-pair Ethernet segment can therefore send a frame whose reassembled size exceeds the configured buffer, causing the driver's RX offload thread to write attacker-controlled frame bytes past the end of the static buffer into adjacent driver/kernel memory (up to roughly 14.8 KB in the worst case). This is a remotely/adjacently reachable out-of-bounds write (CWE-787) that can corrupt memory and cause denial of service or potentially code execution. The defect was introduced when OA SPI support was added (commit 0ca8b0756b1) and shipped in releases v3.7.0 through v4.4.0. The fix adds a bounds check that drops the oversized frame and resets the cursor before the copy. |
| IBM Security Verify Access 10.0 through 10.0.9.2 and IBM Verify Identity Access 11.0 through 11.0.3 and IBM Verify Identity Access Container 11.0 through 11.0.3 Reverse Proxy in certain configurations may provide weaker than expected cryptographic validation of user supplied data. |
| IBM Planning Analytics 2.0, and 2.1 Local is vulnerable to cross-site request forgery which could allow an attacker to execute malicious and unauthorized actions transmitted from a user that the website trusts. |
| IBM WebSphere Application Server - Liberty 17.0.0.3 through 26.0.0.8 is vulnerable to a privilege escalation when using Liberty collectives. |
| A time-of-check to time-of-use (TOCTOU) race condition in the installation and uninstallation process of certain Zoom Clients for Windows could allow an authenticated local user to escalate privileges. |
| In the Linux kernel, the following vulnerability has been resolved:
netfilter: xt_u32: reject invalid shift counts
u32_match_it() executes rule-supplied shift operands on a 32-bit
value. A malformed u32 rule can provide a shift count of 32 or more,
triggering an undefined shift out-of-bounds during packet evaluation.
Validate XT_U32_LEFTSH and XT_U32_RIGHTSH operands in
u32_mt_checkentry() and reject malformed rules before they reach the
packet path. |
| In the Linux kernel, the following vulnerability has been resolved:
ice: fix FDIR CTRL VSI resource leak in ice_reset_all_vfs()
Resetting all VFs causes resource leak on VFs with FDIR filters
enabled as CTRL VSIs are only invalidated and not freed. Fix by using
ice_vf_ctrl_vsi_release() instead of ice_vf_ctrl_invalidate_vsi() which
aligns behavior with the ice_reset_vf() function.
Reproduction:
echo 1 > /sys/class/net/$pf/device/sriov_numvfs
ethtool -N $vf flow-type ether proto 0x9000 action 0
echo 1 > /sys/class/net/$pf/device/reset |
| New API is a large language mode (LLM) gateway and artificial intelligence (AI) asset management system. Prior to 1.0.0-rc.11, POST /api/stripe/webhook, POST /api/creem/webhook, and POST /api/waffo/webhook read and log full request bodies before signature validation in router/api-router.go and the payment controllers, allowing an unauthenticated attacker to cause memory pressure, container restarts, or disk exhaustion without forging a successful payment. This issue is fixed in version 1.0.0-rc.11. |
| websocket-driver is a WebSocket protocol handler with pluggable I/O. Prior to 0.8.2, WebSocket::Driver.server() passes a malformed Host header to URI.parse in lib/websocket/http/request.rb without catching URI::InvalidURIError, allowing a remote client to crash a TCP-backed WebSocket server when the application does not catch the error from parse(). This issue is fixed in version 0.8.2. |
| The ARM PL011 UART driver in drivers/serial/uart_pl011.c fails to acknowledge receive error interrupts. On the PL011, the framing, parity, break, and overrun error interrupts (PL011_IMSC_ERROR_MASK) are cleared only by writing the interrupt-clear register UARTICR; reading the data register clears the RX interrupt and the per-byte RSR status but not the error interrupt status in MIS. The interrupt service routine pl011_isr() acknowledged only the CTS modem-status interrupt and never wrote icr for the error bits, so an asserted error interrupt remains pending after the ISR returns.
When an application enables error-interrupt reporting via the public uart_irq_err_enable() API, an attacker who controls the serial peer can deterministically assert these error bits by injecting line errors on the RX line — a baud/stop-bit mismatch or mid-character break (framing/break error), a flipped parity bit (parity error), or FIFO flooding (overrun error). Because the error interrupt is never cleared, the interrupt line stays asserted and the CPU re-enters pl011_isr() immediately and indefinitely, producing an interrupt-storm livelock from which the core makes no forward progress.
The impact is an availability-only denial of service (permanent hang), reachable from an external or removable UART peer. Exploitation is gated by configuration: the error interrupt is off by default and no in-tree subsystem enables it, so only applications that explicitly call uart_irq_err_enable() on a PL011-based, interrupt-driven port are affected. The fix makes pl011_isr() acknowledge the pending error bits via uart->icr, breaking the loop, and additionally clears the latched RSR status in pl011_err_check(). |
| TLS hostname verification issue in Apache Ranger Client Code in versions <= 2.8.0.
Users are recommended to upgrade to version 2.9.0, which fixes this issue. |
| Improper Privilege Management in Zoom Rooms for Windows before version 7.1.0 may allow an authenticated user to conduct an escalation of privilege via local access. |
