| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| GNU gzip contains a global buffer overflow vulnerability in the LZH decompression logic caused by improper reuse of shared global state between different decompression formats within a single execution. GNU gzip maintains a global array that is shared across the LZ77, LZW, and LZH decompression routines and is not reinitialized between files processed in the same invocation.
By decompressing a specially crafted LZW file followed by a specially crafted LZH file in a single gzip -d command, an attacker can poison the shared global state and subsequently trigger an out‑of‑bounds read in the LZH decoder. The LZH decompression logic follows stale values left in the shared array, causing reads past the end of the allocated global buffer.
This issue has been fixed in commits 63dbf6b3b9e6e781df1a6a64e609b10e23969681 and e7378c2d421be6a286922374425680bbe9ad8b7d. |
| In the Linux kernel, the following vulnerability has been resolved:
crypto: qce - fix error path in devm_qce_register_algs
If ops->register_algs() fails, the error path repeatedly calls the same
ops->unregister_algs() from the failed registration. Use the loop index
to unregister the previously registered algorithms instead. |
| In the Linux kernel, the following vulnerability has been resolved:
ovpn: fix NULL dereference when killing missing key
ovpn_crypto_kill_key assumes both crypto slots are populated and
dereferences each slot before checking it. That is not guaranteed: a
peer can have only one installed key, and the kill path may be asked to
remove a key that is not present.
Read each slot once while holding the crypto state lock, check for NULL
before looking at key_id, and only replace the slot that actually
matches. |
| Unauthenticated Broken Access Control in Kali Forms <= 2.4.23 versions. |
| In the Linux kernel, the following vulnerability has been resolved:
net: ngbe: fix NULL pointer dereference in non-MSI-X interrupt enabling
In non-MSI-X mode (such as legacy INTx or single MSI), wx->msix_entry is
not allocated or initialized. Calling NGBE_INTR_MISC(wx) dereferences
wx->msix_entry->entry, leading to a NULL pointer dereference crash.
This issue was introduced by fixing the IRQ vector when the number of
VFs is 7. Fix the issue by explicitly checking `pdev->msix_enabled` to
determine the correct vector index.
Additionally, as a side fix, set the interrupt mask to BIT(0) for the
non-MSI-X fallback. In MSI/INTx mode, the MISC and queue interrupts
share vector 0, and the WX_PX_MISC_IVAR register is only valid in the
MSI-X case. Thus, BIT(0) is the correct mask for the miscellaneous cause
when MSI-X is disabled. |
| In the Linux kernel, the following vulnerability has been resolved:
Input: sur40 - fix input device registration ordering
In sur40_probe(), input_register_device() was previously called early before
the V4L2 video device and vb2_queue components were fully initialized. If
userspace opened the input device immediately upon registration, sur40_open()
would trigger and start the sur40_poll() worker thread. This worker thread
invokes sur40_process_video() and accesses the uninitialized vb2_queue
structure, leading to a data race and potential system crash.
Furthermore, if V4L2 or video registration failed after input_register_device()
succeeded, the error path fell through to calling input_free_device() on a
successfully registered device instead of input_unregister_device(), corrupting
input core state.
Move input_register_device() to the very end of sur40_probe(). This ensures
the V4L2 and video queue structures are fully initialized before polling can
start, and naturally resolves the error path bug since input_free_device()
is now only called when input registration has not yet occurred.
To maintain strict LIFO (Last-In, First-Out) teardown ordering, also move
input_unregister_device() to the very beginning of sur40_disconnect(). This
guarantees that the input polling worker thread is stopped before V4L2
video components or control handlers are unregistered. |
| Improper Validation of Specified Index, Position, or Offset in Input vulnerability in Mitsubishi Electric CNC M800V Series M800VW and M800VS, M80V Series M80V and M80VW, M800 Series M800W and M800S, M80 Series M80 and M80W, E80 Series E80, C80 Series C80, and M700V Series M750VW, M720VW, 730VW, M720VS, M730VS, and M750VS, M70V Series M70V, E70 Series E70 allows a remote attacker to cause an out-of-bounds read, resulting in a denial-of-service condition by sending specially crafted packets to TCP port 683. |
| In the Linux kernel, the following vulnerability has been resolved:
net: ethernet: ti: am65-cpsw-nuss: Fix port_id extraction from SRC TAG
On the packet reception path, the ID of the MAC Port on which the packet
was received, is embedded in the RX DMA Descriptor's metadata. The ID is
extracted using the helper function cppi5_desc_get_tags_ids() which fills
in the 16-bit Source Tag into the 'port_id' variable. However, it is only
the lower 8-bits of the 16-bit Source Tag that represent the MAC Port ID,
while the upper 8-bits are Hardware-Reserved and carry an arbitrary value.
With the existing logic, sporadic kernel crash is observed due to the
subsequent driver code accessing out-of-bound memory because of an invalid
port_id.
Hence, fix the port_id extraction logic to use only the lower 8-bits of the
Source Tag as the MAC Port ID. |
| Editor Arbitrary File Deletion in Fluent Boards Pro <= 2.0.11 versions. |
| In the Linux kernel, the following vulnerability has been resolved:
xfs: avoid UAF on sc->tempip in xrep_tempfile_create
LOLLM noticed a potential UAF if the tempfile creation code fails after
it set sc->tempip. Fix that. |
| Subscriber Sensitive Data Exposure in SureFeedback Client Site <= 1.2.12 versions. |
| In the Linux kernel, the following vulnerability has been resolved:
Input: synaptics-rmi4 - block s_input when F54 queue is busy
Changing the input (diagnostic report type) mid-stream changes the
report size. Since V4L2 buffers are allocated based on the size at
stream start, changing the input while streaming could lead to a
heap buffer overflow if the new size is larger than the allocated
buffers.
Prevent this by blocking VIDIOC_S_INPUT with -EBUSY if the V4L2 queue
is busy (streaming). |
| In the Linux kernel, the following vulnerability has been resolved:
clk: spacemit: k3: set hdma clock as critical
HDMA clock is responsible for the internal TCM access path of X100 RISC-V
core, so set the clock flag as critical to prevent it from being shut off,
otherwise the Linux system will hang, for example in the case of a vector
instruction access generates a page fault. |
| Improper Validation of Specified Quantity in Input vulnerability in Mitsubishi Electric Corporation CC-Link IE TSN Remote I/O module, CC-Link IE TSN Analog-Digital Converter module, CC-Link IE TSN Digital-Analog Converter module, CC-Link IE TSN FPGA module, CC-Link IE TSN Remote Station Communication LSI CP620 with GbE-PHY, MELSEC iQ-R Series CC-Link IE TSN Master/Local Module, MELSEC iQ-R Series Ethernet Interface Module, CC-Link IE TSN Master/Local Station Communication LSI CP610, MELSEC iQ-F Series FX5 CC-Link IE TSN Master/Local Module, MELSEC iQ-F Series FX5 Ethernet Module, MELSEC iQ-F Series FX5-ENET/IP Ethernet Module, and MELSEC iQ-R Series CPU module allows a remote unauthenticated attacker to cause a Denial of Service condition in the products by sending specially crafted UDP packets. |
| In the Linux kernel, the following vulnerability has been resolved:
Input: iforce - validate input packet lengths
iforce_process_packet() reads fixed fields from joystick, wheel and
status packets without first checking their lengths. In particular, the
shared hats-and-buttons helper unconditionally reads data[6]. The status
tail is a sequence of 16-bit effect addresses, but an incomplete final
address is also consumed. A successful zero-length USB URB additionally
reads the packet ID before the common parser is called.
Reject the zero-length USB transfer, require the seven-byte joystick and
wheel prefixes and the two-byte status prefix, and consume only complete
status-tail addresses. |
| In the Linux kernel, the following vulnerability has been resolved:
xfs: propagate errors from xfs_rtginode_load
xfs_rtginode_ensure() treats every xfs_rtginode_load() error other than
-ENOENT as success. This can leave the realtime group inode unset after an
I/O, allocation, or corruption error. Growfs then continues as though the
inode had been loaded.
Only -ENOENT means that the inode needs to be created. Return all other
errors to the growfs caller. |
| In the Linux kernel, the following vulnerability has been resolved:
xfs: fix off-by-one in rtrefcount btree root level validation
xfs_rtrefcountbt_compute_maxlevels() sets
mp->m_rtrefc_maxlevels = min(d_maxlevels, r_maxlevels) + 1;
where the trailing "+ 1" already accounts for the inode-root level, so the
deepest valid on-disk root level is m_rtrefc_maxlevels - 1 and a cursor must
satisfy bc_nlevels <= bc_maxlevels (= m_rtrefc_maxlevels).
The two on-disk validation paths, xfs_rtrefcountbt_verify() and
xfs_iformat_rtrefcount(), check the root level with ">" instead of ">=", so a
crafted rtreflink (metadir + realtime + reflink) image whose
/rtgroups/N.refcount inode has bb_level == m_rtrefc_maxlevels is accepted on
mount. xfs_rtrefcountbt_init_cursor() then sets bc_nlevels = bb_level + 1,
exceeding bc_maxlevels by one. Since the xfs_rtrefcountbt_cur slab object is
sized for exactly bc_maxlevels entries, the first btree op on such a cursor
indexes bc_levels[m_rtrefc_maxlevels] past the end of the object. This is
reached by the first rtrefcount cursor built after mount, via log/CoW
recovery (xfs_reflink_recover_cow() during xfs_mountfs()) or an
FS_IOC_GETFSMAP over the realtime device.
Reject a root level equal to m_rtrefc_maxlevels, matching the ">=" form
already used by the sibling data-device refcount/rmap verifiers and the
in-memory rtrmap verifier.
BUG: KASAN: slab-out-of-bounds in xfs_btree_lookup (fs/xfs/libxfs/xfs_btree.c:2101)
Write of size 2 at addr ffff888018391658 by task exploit/144
xfs_btree_lookup (fs/xfs/libxfs/xfs_btree.c:2101)
xfs_btree_query_range (fs/xfs/libxfs/xfs_btree.c:5308)
xfs_refcount_recover_cow_leftovers (fs/xfs/libxfs/xfs_refcount.c:2113)
xfs_reflink_recover_cow (fs/xfs/xfs_reflink.c:1085)
xlog_recover_finish (fs/xfs/xfs_log_recover.c:3551)
xfs_mountfs (fs/xfs/xfs_mount.c:1158)
xfs_fs_fill_super (fs/xfs/xfs_super.c:1940)
get_tree_bdev_flags (fs/super.c:1634)
vfs_get_tree (fs/super.c:1694)
path_mount (fs/namespace.c:4161)
__x64_sys_mount (fs/namespace.c:4367)
entry_SYSCALL_64_after_hwframe (arch/x86/entry/entry_64.S:121)
The buggy address belongs to the cache xfs_rtrefcountbt_cur of size 216
The buggy address is located 8 bytes to the right of
allocated 216-byte region [ffff888018391578, ffff888018391650)
Kernel panic - not syncing: Fatal exception |
| This CVE ID has been rejected or withdrawn by its CVE Numbering Authority because it is Unused |
| This CVE ID has been rejected or withdrawn by its CVE Numbering Authority because it is Unused |
| This CVE ID has been rejected or withdrawn by its CVE Numbering Authority because it is Unused |
