| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| In the Linux kernel, the following vulnerability has been resolved:
xfs: avoid UAF on sc->tempip in xrep_tempfile_create
LOLLM noticed a potential UAF if the tempfile creation code fails after
it set sc->tempip. Fix that. |
| Subscriber Sensitive Data Exposure in SureFeedback Client Site <= 1.2.12 versions. |
| In the Linux kernel, the following vulnerability has been resolved:
Input: synaptics-rmi4 - block s_input when F54 queue is busy
Changing the input (diagnostic report type) mid-stream changes the
report size. Since V4L2 buffers are allocated based on the size at
stream start, changing the input while streaming could lead to a
heap buffer overflow if the new size is larger than the allocated
buffers.
Prevent this by blocking VIDIOC_S_INPUT with -EBUSY if the V4L2 queue
is busy (streaming). |
| In the Linux kernel, the following vulnerability has been resolved:
clk: spacemit: k3: set hdma clock as critical
HDMA clock is responsible for the internal TCM access path of X100 RISC-V
core, so set the clock flag as critical to prevent it from being shut off,
otherwise the Linux system will hang, for example in the case of a vector
instruction access generates a page fault. |
| Improper Validation of Specified Quantity in Input vulnerability in Mitsubishi Electric Corporation CC-Link IE TSN Remote I/O module, CC-Link IE TSN Analog-Digital Converter module, CC-Link IE TSN Digital-Analog Converter module, CC-Link IE TSN FPGA module, CC-Link IE TSN Remote Station Communication LSI CP620 with GbE-PHY, MELSEC iQ-R Series CC-Link IE TSN Master/Local Module, MELSEC iQ-R Series Ethernet Interface Module, CC-Link IE TSN Master/Local Station Communication LSI CP610, MELSEC iQ-F Series FX5 CC-Link IE TSN Master/Local Module, MELSEC iQ-F Series FX5 Ethernet Module, MELSEC iQ-F Series FX5-ENET/IP Ethernet Module, and MELSEC iQ-R Series CPU module allows a remote unauthenticated attacker to cause a Denial of Service condition in the products by sending specially crafted UDP packets. |
| In the Linux kernel, the following vulnerability has been resolved:
Input: iforce - validate input packet lengths
iforce_process_packet() reads fixed fields from joystick, wheel and
status packets without first checking their lengths. In particular, the
shared hats-and-buttons helper unconditionally reads data[6]. The status
tail is a sequence of 16-bit effect addresses, but an incomplete final
address is also consumed. A successful zero-length USB URB additionally
reads the packet ID before the common parser is called.
Reject the zero-length USB transfer, require the seven-byte joystick and
wheel prefixes and the two-byte status prefix, and consume only complete
status-tail addresses. |
| In the Linux kernel, the following vulnerability has been resolved:
xfs: propagate errors from xfs_rtginode_load
xfs_rtginode_ensure() treats every xfs_rtginode_load() error other than
-ENOENT as success. This can leave the realtime group inode unset after an
I/O, allocation, or corruption error. Growfs then continues as though the
inode had been loaded.
Only -ENOENT means that the inode needs to be created. Return all other
errors to the growfs caller. |
| In the Linux kernel, the following vulnerability has been resolved:
xfs: fix off-by-one in rtrefcount btree root level validation
xfs_rtrefcountbt_compute_maxlevels() sets
mp->m_rtrefc_maxlevels = min(d_maxlevels, r_maxlevels) + 1;
where the trailing "+ 1" already accounts for the inode-root level, so the
deepest valid on-disk root level is m_rtrefc_maxlevels - 1 and a cursor must
satisfy bc_nlevels <= bc_maxlevels (= m_rtrefc_maxlevels).
The two on-disk validation paths, xfs_rtrefcountbt_verify() and
xfs_iformat_rtrefcount(), check the root level with ">" instead of ">=", so a
crafted rtreflink (metadir + realtime + reflink) image whose
/rtgroups/N.refcount inode has bb_level == m_rtrefc_maxlevels is accepted on
mount. xfs_rtrefcountbt_init_cursor() then sets bc_nlevels = bb_level + 1,
exceeding bc_maxlevels by one. Since the xfs_rtrefcountbt_cur slab object is
sized for exactly bc_maxlevels entries, the first btree op on such a cursor
indexes bc_levels[m_rtrefc_maxlevels] past the end of the object. This is
reached by the first rtrefcount cursor built after mount, via log/CoW
recovery (xfs_reflink_recover_cow() during xfs_mountfs()) or an
FS_IOC_GETFSMAP over the realtime device.
Reject a root level equal to m_rtrefc_maxlevels, matching the ">=" form
already used by the sibling data-device refcount/rmap verifiers and the
in-memory rtrmap verifier.
BUG: KASAN: slab-out-of-bounds in xfs_btree_lookup (fs/xfs/libxfs/xfs_btree.c:2101)
Write of size 2 at addr ffff888018391658 by task exploit/144
xfs_btree_lookup (fs/xfs/libxfs/xfs_btree.c:2101)
xfs_btree_query_range (fs/xfs/libxfs/xfs_btree.c:5308)
xfs_refcount_recover_cow_leftovers (fs/xfs/libxfs/xfs_refcount.c:2113)
xfs_reflink_recover_cow (fs/xfs/xfs_reflink.c:1085)
xlog_recover_finish (fs/xfs/xfs_log_recover.c:3551)
xfs_mountfs (fs/xfs/xfs_mount.c:1158)
xfs_fs_fill_super (fs/xfs/xfs_super.c:1940)
get_tree_bdev_flags (fs/super.c:1634)
vfs_get_tree (fs/super.c:1694)
path_mount (fs/namespace.c:4161)
__x64_sys_mount (fs/namespace.c:4367)
entry_SYSCALL_64_after_hwframe (arch/x86/entry/entry_64.S:121)
The buggy address belongs to the cache xfs_rtrefcountbt_cur of size 216
The buggy address is located 8 bytes to the right of
allocated 216-byte region [ffff888018391578, ffff888018391650)
Kernel panic - not syncing: Fatal exception |
| This CVE ID has been rejected or withdrawn by its CVE Numbering Authority because it is Unused |
| This CVE ID has been rejected or withdrawn by its CVE Numbering Authority because it is Unused |
| This CVE ID has been rejected or withdrawn by its CVE Numbering Authority because it is Unused |
| This CVE ID has been rejected or withdrawn by its CVE Numbering Authority because it is Unused |
| This CVE ID has been rejected or withdrawn by its CVE Numbering Authority because it is Unused |
| This CVE ID has been rejected or withdrawn by its CVE Numbering Authority because it is Unused |
| This CVE ID has been rejected or withdrawn by its CVE Numbering Authority because it is Unused |
| This CVE ID has been rejected or withdrawn by its CVE Numbering Authority because it is Unused |
| This CVE ID has been rejected or withdrawn by its CVE Numbering Authority because it is Unused |
| This CVE ID has been rejected or withdrawn by its CVE Numbering Authority because it is Unused |
| This CVE ID has been rejected or withdrawn by its CVE Numbering Authority because it is Unused |
| This CVE ID has been rejected or withdrawn by its CVE Numbering Authority because it is Unused |
