| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| In the Linux kernel, the following vulnerability has been resolved:
scsi: ibmvfc: Fix OOB access in ibmvfc_discover_targets_done()
A malicious or compromised VIO server can return a num_written value in the
discover targets MAD response that exceeds max_targets. This value is
stored directly in vhost->num_targets without validation, and is then used
as the loop bound in ibmvfc_alloc_targets() to index into disc_buf[], which
is only allocated for max_targets entries. Indices at or beyond max_targets
access kernel memory outside the DMA-coherent allocation. The
out-of-bounds data is subsequently embedded in Implicit Logout and PLOGI
MADs that are sent back to the VIO server, leaking kernel memory.
Fix by clamping num_written to max_targets before storing it. |
| In the Linux kernel, the following vulnerability has been resolved:
ext4: validate p_idx bounds in ext4_ext_correct_indexes
ext4_ext_correct_indexes() walks up the extent tree correcting
index entries when the first extent in a leaf is modified. Before
accessing path[k].p_idx->ei_block, there is no validation that
p_idx falls within the valid range of index entries for that
level.
If the on-disk extent header contains a corrupted or crafted
eh_entries value, p_idx can point past the end of the allocated
buffer, causing a slab-out-of-bounds read.
Fix this by validating path[k].p_idx against EXT_LAST_INDEX() at
both access sites: before the while loop and inside it. Return
-EFSCORRUPTED if the index pointer is out of range, consistent
with how other bounds violations are handled in the ext4 extent
tree code. |
| No cwe for this issue in Microsoft Office SharePoint allows an authorized attacker to elevate privileges over a network. |
| Improper validation of specified type of input in .NET Framework allows an unauthorized attacker to perform tampering over a network. |
| In the Linux kernel, the following vulnerability has been resolved:
net/mdiobus: Fix potential out-of-bounds clause 45 read/write access
When using publicly available tools like 'mdio-tools' to read/write data
from/to network interface and its PHY via C45 (clause 45) mdiobus,
there is no verification of parameters passed to the ioctl and
it accepts any mdio address.
Currently there is support for 32 addresses in kernel via PHY_MAX_ADDR define,
but it is possible to pass higher value than that via ioctl.
While read/write operation should generally fail in this case,
mdiobus provides stats array, where wrong address may allow out-of-bounds
read/write.
Fix that by adding address verification before C45 read/write operation.
While this excludes this access from any statistics, it improves security of
read/write operation. |
| Backstage is an open framework for building developer portals. Prior to 0.29.2, the experimental dynamic client registration and client ID metadata document features in the @backstage/plugin-auth-backend use full-string matcher.isMatch glob matching for auth.experimentalDynamicClientRegistration.allowedRedirectUriPatterns and the auth.experimentalClientIdMetadataDocuments allowedClientIdPatterns and allowedRedirectUriPatterns options. A hostname wildcard can match across URL component boundaries, allowing an attacker-controlled redirect URI with a trusted hostname suffix in its path to pass the allowlist and receive an OAuth authorization code after a victim completes the flow. Patterns without an explicit protocol can match unintended protocols, and redirect URIs containing embedded credentials are accepted after user information is stripped for matching. The features are experimental and disabled by default; only deployments that enable them and configure custom wildcard-hostname or protocol-less patterns are affected. This issue is first fixed in prerelease version 0.29.2. |
| Improper Validation of Specified Quantity in Input vulnerability in Magepeople inc. Booking and Rental Manager booking-and-rental-manager-for-woocommerce allows Removing Important Client Functionality.This issue affects Booking and Rental Manager: from n/a through 2.8.0. |
| Godot Engine through 4.7.2 has an out-of-bounds read in the optimized translation loader (core/string/optimized_translation.cpp, OptimizedTranslation::get_message). Offsets read from the hash table of a crafted .translation resource are used as indices into the bucket table without bounds validation; only a single sentinel value is rejected. A crafted file can point an index far past the allocated buffer. Depending on the values, the result is a crash, or a string lookup (tr()) returns raw bytes from elsewhere in the process heap as the translated string, disclosing process memory. The defect is reached when the product or an exported game loads and performs lookups in a crafted translation file. NOTE: the Supplier's position is that the research has identified "no security issues" because the required attacker access is outside of the current Godot Engine threat model. |
| In the Linux kernel, the following vulnerability has been resolved:
wifi: b43legacy: enforce bounds check on firmware key index in RX path
Same fix as b43: the firmware-controlled key index in b43legacy_rx()
can exceed dev->max_nr_keys. The existing B43legacy_WARN_ON is
non-enforcing in production builds, allowing an out-of-bounds read of
dev->key[].
Make the check enforcing by dropping the frame for invalid indices. |
| In the Linux kernel, the following vulnerability has been resolved:
misc: ibmasm: fix OOB MMIO read in ibmasm_handle_mouse_interrupt()
ibmasm_handle_mouse_interrupt() performs an out-of-bounds MMIO read
when the queue reader or writer index from hardware exceeds
REMOTE_QUEUE_SIZE (60).
A compromised service processor can trigger this by writing an
out-of-range value to the reader or writer MMIO register before
asserting an interrupt. Since writer is re-read from hardware on
every loop iteration, it can also be set to an out-of-range value
after the loop has already started.
The root cause is that get_queue_reader() and get_queue_writer() return
raw readl() values that are passed directly into get_queue_entry(),
which computes:
queue_begin + reader * sizeof(struct remote_input)
with no bounds check. This unchecked MMIO address is then passed to
memcpy_fromio(), reading 8 bytes from unintended device registers.
For sufficiently large values the address falls outside the PCI BAR
mapping entirely, triggering a machine check exception.
Fix by checking both indices against REMOTE_QUEUE_SIZE at the top of
the loop body, before any call to get_queue_entry(). On an out-of-range
value, reset the reader register to 0 via set_queue_reader() before
breaking, so that normal queue operation can resume if the corrupted
hardware state is transient. |
| In the Linux kernel, the following vulnerability has been resolved:
ksmbd: require minimum ACE size in smb_check_perm_dacl()
Both ACE-walk loops in smb_check_perm_dacl() only guard against an
under-sized remaining buffer, not against an ACE whose declared
`ace->size` is smaller than the struct it claims to describe:
if (offsetof(struct smb_ace, access_req) > aces_size)
break;
ace_size = le16_to_cpu(ace->size);
if (ace_size > aces_size)
break;
The first check only requires the 4-byte ACE header to be in bounds;
it does not require access_req (4 bytes at offset 4) to be readable.
An attacker who has set a crafted DACL on a file they own can declare
ace->size == 4 with aces_size == 4, pass both checks, and then
granted |= le32_to_cpu(ace->access_req); /* upper loop */
compare_sids(&sid, &ace->sid); /* lower loop */
reads access_req at offset 4 (OOB by up to 4 bytes) and ace->sid at
offset 8 (OOB by up to CIFS_SID_BASE_SIZE + SID_MAX_SUB_AUTHORITIES
* 4 bytes).
Tighten both loops to require
ace_size >= offsetof(struct smb_ace, sid) + CIFS_SID_BASE_SIZE
which is the smallest valid on-wire ACE layout (4-byte header +
4-byte access_req + 8-byte sid base with zero sub-auths). Also
reject ACEs whose sid.num_subauth exceeds SID_MAX_SUB_AUTHORITIES
before letting compare_sids() dereference sub_auth[] entries.
parse_sec_desc() already enforces an equivalent check (lines 441-448);
smb_check_perm_dacl() simply grew weaker validation over time.
Reachability: authenticated SMB client with permission to set an ACL
on a file. On a subsequent CREATE against that file, the kernel
walks the stored DACL via smb_check_perm_dacl() and triggers the
OOB read. Not pre-auth, and the OOB read is not reflected to the
attacker, but KASAN reports and kernel state corruption are
possible. |
| In the Linux kernel, the following vulnerability has been resolved:
ksmbd: require 3 sub-authorities before reading sub_auth[2]
parse_dacl() compares each ACE SID against sid_unix_NFS_mode and on
match reads sid.sub_auth[2] as the file mode. If sid_unix_NFS_mode is
the prefix S-1-5-88-3 with num_subauth = 2 then compare_sids() compares
only min(num_subauth, 2) sub-authorities so a client SID with
num_subauth = 2 and sub_auth = {88, 3} will match.
If num_subauth = 2 and the ACE is placed at the very end of the security
descriptor, sub_auth[2] will be 4 bytes past end_of_acl. The
out-of-band bytes will then be masked to the low 9 bits and applied as
the file's POSIX mode, probably not something that is good to have
happen.
Fix this up by forcing the SID to actually carry a third sub-authority
before reading it at all. |
| When curl is used to retrieve and parse cookies from a HTTP(S) server, itaccepts cookies using control codes that when later are sent back to a HTTPserver might make the server return 400 responses. Effectively allowing a"sister site" to deny service to all siblings. |
| Out-of-bounds Write (CWE-787) in the PEA archive extraction routine (pea.pas, unpea_procedure) of the first-party pea component in PeaZip 11.2.0 and earlier allows an attacker who convinces a victim to open or extract a crafted .pea archive to execute arbitrary code as the user running PeaZip. While decompressing a PCOMPRESS1 stream, the 32-bit compressed-block-size field of the first block (compsize) is read directly from the archive and used without validation as the length of a blockread into the fixed-size global buffers wbuf1/wbuf2 (1,114,112 bytes) and as the bound of the subsequent copy loop. The existing check "compsize > WBUFSIZE" is applied only to the size of each following block, so the first block escapes it; the same unvalidated value is also used to index wbuf1[compsize], an out-of-bounds read at an attacker-chosen offset. The copy loop additionally copies the requested length instead of the number of bytes actually read, and terminates on equality rather than on an upper bound. Because the project is built without range checking and no archive password, integrity tag or non-default configuration is required, the overflow overwrites adjacent global data; code execution was demonstrated by two independent researchers against the official Linux x86-64 and Windows x64 builds, and the denial-of-service and memory-corruption primitive is cross-platform (Windows, macOS, Linux, BSD). |
| MariaDB server is a community developed fork of MySQL server. From 10.6.1 until 10.6.28, 10.11.19, 11.4.13, 11.8.9, 12.3.3, and 13.0.2, MariaDB insufficiently validated counts, offsets, lengths, and field boundaries in FRM metadata while opening binary FRM files. An attacker able to place a crafted FRM file in the data directory could trigger out-of-bounds reads or writes, crash the server, or potentially execute code. This issue is fixed in versions 10.6.28, 10.11.19, 11.4.13, 11.8.9, 12.3.3, and 13.0.2. |
| Dell Secure Connect Gateway (SCG) Policy Manager, versions prior to 5.34.00.16, contains an Improper Validation of Specified Type of Input vulnerability. A low privileged attacker with remote access could potentially exploit this vulnerability, leading to Information exposure and Information tampering. |
| fast-jwt provides fast JSON Web Token (JWT) implementation. Prior to 6.3.0, fast-jwt createVerifier accepts a validly signed JWT whose payload is a JSON array because src/decoder.js checks that the payload is an object but does not reject arrays. The claim validator loop then finds no named exp, nbf, iss, aud, sub, jti, or nonce properties and silently skips those configured checks, returning the array as a successfully verified payload. An attacker who can produce or influence a validly signed token may bypass expiry, issuer, audience, subject, revocation, and replay protections. The opt-in requiredClaims option can block missing claims, and signature verification itself is not bypassed. This issue is fixed in version 6.3.0. |
| Gitoxide gix-pack before 0.75.0 contains a denial of service vulnerability that allows malicious remotes to crash fetch operations by sending crafted thin-pack OFS_DELTA entries. Attackers can serve a thin pack with a REF_DELTA referencing an existing object followed by an OFS_DELTA whose base_distance exceeds pack_offset, triggering a panic in LookupRefDeltaObjectsIter that aborts the fetch process. |
| modern-tar 0.3.5 through 0.8.5 contains a memory exhaustion vulnerability that allows attackers to produce negative entry sizes via non-octal bytes parsed by readOctal(). Attackers can supply a crafted, optionally gzip-compressed, archive to unpackTar() that buffers chunks indefinitely, exhausting process memory and suppressing later entries. |
| Pydantic AI is a Python agent framework for building applications and workflows with Generative AI. From 1.77.0 until 1.107.6 and 2.44.0, the local web_fetch_tool and the WebFetch local fallback compare blocked_domains entries with a URL hostname before both values are normalized to the form used by getaddrinfo. An attacker-influenced model can use an equivalent IDNA spelling, non-ASCII label separator, case variation, or trailing root label that resolves to a blocked host but does not match the configured string, causing the application to fetch that host with its own privileges. allowed_domains fails closed for unmatched spellings, and private-IP and cloud-metadata protections remain effective. This issue is fixed in versions 1.107.6 and 2.44.0. |
