| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| In the Linux kernel, the following vulnerability has been resolved:
iio: magnetometer: ak8975: fix potential kernel stack memory leak
Currently in the AK8975 driver there are four instances where potential
uninitialized kernel stack memory leaks can occur. If
i2c_smbus_read_i2c_block_data_or_emulated() returns a value less than
the size of the buffer, uninitialized bytes are retained in the buffer
and later the buffer is passed on to IIO buffers, potentially leaking
memory to userspace.
Fix this by adding checks whether the return value of the function is
equal to the size of the buffer and subsequently if the value is
lesser than zero to distinguish from a returned error code. |
| In the Linux kernel, the following vulnerability has been resolved:
apparmor: fix NULL pointer dereference in unpack_pdb
pdb->dfa could be NULL if unpack_dfa fails, causing a NULL pointer
dereference. |
| In the Linux kernel, the following vulnerability has been resolved:
bpf: Fix stack slot index in nospec checks
check_stack_write_fixed_off() computes the byte slot for a fixed-offset
stack write as -off - 1, and records each written byte in slot_type[] with
(slot - i) % BPF_REG_SIZE.
The Spectre v4 sanitization pre-check uses slot_type[i] instead. For a
4-byte write at fp-8 after the lower half of fp-8 has been zeroed, the
pre-check scans bytes 0..3 and sees STACK_ZERO while the actual write updates
bytes 7..4. That can leave the second half-slot write without nospec_result
even though the bytes being overwritten still require sanitization.
Use the same slot index in the sanitization pre-check that the write path uses
when updating slot_type[]. |
| In the Linux kernel, the following vulnerability has been resolved:
ALSA: FCP: Fix NULL pointer dereference in interface lookup
A malformed USB device can provide a vendor-specific interface without
any endpoint descriptors. fcp_find_fc_interface() currently selects the
first vendor-specific interface and reads endpoint 0 from it, without
checking whether the interface actually has any endpoints.
When bNumEndpoints is zero, no endpoint array is allocated for the parsed
alternate setting, so get_endpoint(..., 0) yields an invalid endpoint
descriptor pointer. Dereferencing it through usb_endpoint_num() then
triggers a NULL pointer dereference.
Skip vendor-specific interfaces that do not have any endpoints. |
| In the Linux kernel, the following vulnerability has been resolved:
hwmon: adm1275: Prevent reading uninitialized stack
While adding support for the ROHM BD127X0 hot-swap controllers, sashiko
reported an error in device-name comparison, which can lead to reading
uninitialized stack memory.
Quoting Sashiko:
This is a pre-existing issue, but I noticed that just before this block in
adm1275_probe(), there might be an out-of-bounds stack read:
ret = i2c_smbus_read_block_data(client, PMBUS_MFR_MODEL, block_buffer);
if (ret < 0) { ... }
for (mid = adm1275_id; mid->name[0]; mid++) {
if (!strncasecmp(mid->name, block_buffer, strlen(mid->name)))
break;
}
Since i2c_smbus_read_block_data() reads up to 32 bytes into the
uninitialized stack array block_buffer without appending a null
terminator, strncasecmp() could read past the valid bytes returned in ret.
For example, if the device returns a shorter string like "adm12", checking
it against "adm1275" up to the length of "adm1275" will continue reading
into uninitialized stack bounds.
Prevent reading uninitialized memory by zeroing the stack array. |
| In the Linux kernel, the following vulnerability has been resolved:
drm/panthor: Fix potential invalid pointer deref in group_process_tiler_oom()
If heaps is an ERR_PTR(), panthor_heap_pool_put() will deref an invalid
pointer. Make sure we set it to NULL in that case. |
| In the Linux kernel, the following vulnerability has been resolved:
tracing/fprobe: Fix NULL pointer dereference in fprobe_fgraph_entry()
fprobe_fgraph_entry() sizes a shadow-stack reservation in one walk of
the per-ip fprobe list and fills it in a second walk, both under
rcu_read_lock() only. A fprobe registered on an already-live ip can
become visible between the two walks, so the fill walk processes an
exit_handler the sizing walk did not count and used runs past
reserved_words. If the sizing walk counted nothing, fgraph_data is NULL
and the first write_fprobe_header() faults:
Oops: general protection fault, probably for non-canonical address ...
KASAN: null-ptr-deref in range [0x0000000000000000-0x0000000000000007]
RIP: 0010:fprobe_fgraph_entry+0xa38/0xf10 kernel/trace/fprobe.c:167
Call Trace:
<TASK>
function_graph_enter_regs+0x44c/0xa10 kernel/trace/fgraph.c:677
ftrace_graph_func+0xc5/0x140 arch/x86/kernel/ftrace.c:671
__kernel_text_address+0x9/0x40 kernel/extable.c:78
arch_stack_walk+0x117/0x170 arch/x86/kernel/stacktrace.c:26
kmem_cache_free+0x188/0x580 mm/slub.c:6378
tcp_data_queue+0x18d/0x6550 net/ipv4/tcp_input.c:5590
[...]
</TASK>
The list cannot be frozen across the two walks, so skip a node that does
not fit the reservation and count it as missed. |
| In the Linux kernel, the following vulnerability has been resolved:
fs: refuse O_TMPFILE creation with an unmapped fsuid or fsgid
vfs_tmpfile() never checked that the caller's fsuid and fsgid map into
the filesystem. On an idmapped mount whose idmapping does not cover the
caller's fs{u,g}id, the ->tmpfile() instance initializes the new inode
through inode_init_owner(), where mapped_fsuid()/mapped_fsgid() return
INVALID_UID/INVALID_GID, and the tmpfile ends up owned by (uid_t)-1.
Every other creation path already refuses this: may_o_create() (O_CREAT)
and may_create_dentry() (mkdir, mknod, symlink, link) bail out with
-EOVERFLOW via fsuidgid_has_mapping() precisely so that an object cannot
be created with an owner the filesystem cannot represent. An O_TMPFILE
is no exception: it is created I_LINKABLE and linkat(2) can splice it
into the namespace afterwards, so the same guarantee must hold.
Add the missing fsuidgid_has_mapping() check to vfs_tmpfile(). On a
non-idmapped mount the caller's fs{u,g}id always map in the superblock's
user namespace, so this is a no-op there and only takes effect on an
idmapped mount that does not map the caller. It applies to every
filesystem that sets FS_ALLOW_IDMAP and implements ->tmpfile() (tmpfs,
ext4, btrfs, xfs, f2fs, ...), and to overlayfs, whose upper-layer
tmpfile creation funnels through vfs_tmpfile() via backing_tmpfile_open(). |
| In the Linux kernel, the following vulnerability has been resolved:
afs: Remove setting of AS_RELEASE_ALWAYS for symlinks and mountpoints
Regular AFS files correctly use afs_file_aops which have release_folio
set as netfs_release_folio, so AS_RELEASE_ALWAYS is valid for them
when fscache is enabled (set via afs_vnode_set_cache()).
Symlinks and mountpoints in AFS use afs_dir_aops, which does not provide
a release_folio callback. However, afs_apply_status() unconditionally
calls mapping_set_release_always() for these.
In such case when memory management code attempts to release folios,
filemap_release_folio() checks folio_needs_release() which
returns true due to AS_RELEASE_ALWAYS being set. Since there is no
release_folio callback, it falls through to try_to_free_buffers(),
which at present expects buffer_heads to be not null. For symlinks
and mountpoints without buffer_heads, this causes pointer dereference.
[dh: Added more bits that were missed] |
| In the Linux kernel, the following vulnerability has been resolved:
drm/v3d: Reject invalid indirect BO handle in indirect CSD setup
v3d_get_cpu_indirect_csd_params() looks up the indirect buffer object
from a userspace-supplied handle but never checks the result. A bogus
or stale handle makes drm_gem_object_lookup() return NULL, which is
then stored in info->indirect and only dereferenced later when the
indirect CSD job runs, turning a userspace mistake into a NULL pointer
dereference in the kernel.
Bail out with -ENOENT as soon as the lookup fails, so the bad handle is
rejected at submission time. |
| In the Linux kernel, the following vulnerability has been resolved:
tracing/remotes: Fix leak in trace_remote_alloc_buffer() error path
If page allocation fails in trace_remote_alloc_buffer(), desc->nr_cpus
is not yet incremented for the current CPU. As a consequence, on error,
half-allocated rb_desc will not be freed in trace_remote_free_buffer().
Increment desc->nr_cpus as soon as the first allocation for the current
CPU has succeeded. |
| In the Linux kernel, the following vulnerability has been resolved:
VDUSE: avoid leaking information to userspace
The bounceing is not necessarily page aligned, so current VDUSE can
leak kernel information through mapping bounce pages to
userspace. Allocate bounce pages with __GFP_ZERO to avoid leaking
information to userspace. |
| In the Linux kernel, the following vulnerability has been resolved:
KVM: s390: Initialize KVM_S390_GET_CMMA_BITS memory
kvm_s390_get_cmma_bits() allocates its output buffer with vmalloc(),
which does not zero the returned pages:
values = vmalloc(args->count);
In the non-peek (migration) path, dat_get_cmma() reports a byte count
spanning from the first to the last dirty page, but __dat_get_cmma_pte()
writes values[gfn - start] only for pages whose CMMA dirty bit is set.
The walk uses DAT_WALK_IGN_HOLES, so clean and unmapped pages that lie
between two dirty pages within the reported span are visited but never
store their byte. Those gaps (up to KVM_S390_MAX_BIT_DISTANCE pages
each) stay uninitialized yet fall inside [0, count) and are copied out
by copy_to_user(), disclosing stale kernel memory to user space.
Before the switch to the new gmap implementation the buffer was fully
populated for every gfn in the span, so no uninitialized bytes were
exposed; the dirty-only walk introduced the leak.
Use vzalloc() so the gaps read back as zero. |
| In the Linux kernel, the following vulnerability has been resolved:
fbdev: i740fb: fix potential memory leak in i740fb_probe()
In i740fb_probe(), the memory allocated in fb_videomode_to_modelist()
for modelist is not freed in the error paths. Fix that by calling
fb_destroy_modelist(). |
| In the Linux kernel, the following vulnerability has been resolved:
fbdev: tdfxfb: fix potential memory leak in tdfxfb_probe()
In tdfxfb_probe(), the memory allocated for modelist using
fb_videomode_to_modelist() when CONFIG_FB_3DFX_I2C is defined, is not
freed in the subsequent error paths.
Fix that by calling fb_destroy_modelist(). |
| In the Linux kernel, the following vulnerability has been resolved:
fbdev: carminefb: fix potential memory leak in alloc_carmine_fb()
The memory allocated for modelist in fb_videomode_to_modelist() is not
freed in the subsequent error path.
Fix that by calling fb_destroy_modelist() |
| This CVE ID has been rejected or withdrawn by its CVE Numbering Authority. |
| In the Linux kernel, the following vulnerability has been resolved:
gpu: host1x: Fix device reference leak in host1x_device_parse_dt() error path
After device_initialize(), the embedded struct device in struct
host1x_device should be released through the device core with
put_device().
In host1x_device_add(), if host1x_device_parse_dt() fails, the current
error path frees the object directly with kfree(device). That bypasses
the normal device lifetime handling and leaks the reference held on the
embedded struct device.
The issue was identified by a static analysis tool I developed and
confirmed by manual review.
Fix this by using put_device() in the host1x_device_parse_dt() failure
path. |
| In the Linux kernel, the following vulnerability has been resolved:
x86/boot: Validate console=uart8250 baud rate to fix early boot hang
When the baud rate is empty, 0, invalid, or overflows to 0 when stored
as an int, the system will hang during early boot because of a division
by zero in early_serial_init().
Fall back to DEFAULT_BAUD when the resulting baud rate is 0 to prevent
an early system hang. |
| In the Linux kernel, the following vulnerability has been resolved:
s390/perf_cpum_cf: Add missing array_index_nospec() to __hw_perf_event_init()
ev variable is userspace controlled via event->attr.config and used
as an array index after bounds checking, but without speculation
barriers.
Add the missing array_index_nospec() call to prevent speculative
execution. |
