| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| REXML is an XML toolkit for Ruby. The REXML gem before 3.3.1 has some DoS vulnerabilities when it parses an XML that has many specific characters such as `<`, `0` and `%>`. If you need to parse untrusted XMLs, you many be impacted to these vulnerabilities. The REXML gem 3.3.2 or later include the patches to fix these vulnerabilities. Users are advised to upgrade. Users unable to upgrade should avoid parsing untrusted XML strings. |
| Insufficient granularity of access control in UEFI firmware in some Intel(R) processors may allow a authenticated user to potentially enable denial of service via local access. |
| In the Linux kernel, the following vulnerability has been resolved:
RDMA/rxe: Fix seg fault in rxe_comp_queue_pkt
In rxe_comp_queue_pkt() an incoming response packet skb is enqueued to the
resp_pkts queue and then a decision is made whether to run the completer
task inline or schedule it. Finally the skb is dereferenced to bump a 'hw'
performance counter. This is wrong because if the completer task is
already running in a separate thread it may have already processed the skb
and freed it which can cause a seg fault. This has been observed
infrequently in testing at high scale.
This patch fixes this by changing the order of enqueuing the packet until
after the counter is accessed. |
| In the Linux kernel, the following vulnerability has been resolved:
net: bridge: xmit: make sure we have at least eth header len bytes
syzbot triggered an uninit value[1] error in bridge device's xmit path
by sending a short (less than ETH_HLEN bytes) skb. To fix it check if
we can actually pull that amount instead of assuming.
Tested with dropwatch:
drop at: br_dev_xmit+0xb93/0x12d0 [bridge] (0xffffffffc06739b3)
origin: software
timestamp: Mon May 13 11:31:53 2024 778214037 nsec
protocol: 0x88a8
length: 2
original length: 2
drop reason: PKT_TOO_SMALL
[1]
BUG: KMSAN: uninit-value in br_dev_xmit+0x61d/0x1cb0 net/bridge/br_device.c:65
br_dev_xmit+0x61d/0x1cb0 net/bridge/br_device.c:65
__netdev_start_xmit include/linux/netdevice.h:4903 [inline]
netdev_start_xmit include/linux/netdevice.h:4917 [inline]
xmit_one net/core/dev.c:3531 [inline]
dev_hard_start_xmit+0x247/0xa20 net/core/dev.c:3547
__dev_queue_xmit+0x34db/0x5350 net/core/dev.c:4341
dev_queue_xmit include/linux/netdevice.h:3091 [inline]
__bpf_tx_skb net/core/filter.c:2136 [inline]
__bpf_redirect_common net/core/filter.c:2180 [inline]
__bpf_redirect+0x14a6/0x1620 net/core/filter.c:2187
____bpf_clone_redirect net/core/filter.c:2460 [inline]
bpf_clone_redirect+0x328/0x470 net/core/filter.c:2432
___bpf_prog_run+0x13fe/0xe0f0 kernel/bpf/core.c:1997
__bpf_prog_run512+0xb5/0xe0 kernel/bpf/core.c:2238
bpf_dispatcher_nop_func include/linux/bpf.h:1234 [inline]
__bpf_prog_run include/linux/filter.h:657 [inline]
bpf_prog_run include/linux/filter.h:664 [inline]
bpf_test_run+0x499/0xc30 net/bpf/test_run.c:425
bpf_prog_test_run_skb+0x14ea/0x1f20 net/bpf/test_run.c:1058
bpf_prog_test_run+0x6b7/0xad0 kernel/bpf/syscall.c:4269
__sys_bpf+0x6aa/0xd90 kernel/bpf/syscall.c:5678
__do_sys_bpf kernel/bpf/syscall.c:5767 [inline]
__se_sys_bpf kernel/bpf/syscall.c:5765 [inline]
__x64_sys_bpf+0xa0/0xe0 kernel/bpf/syscall.c:5765
x64_sys_call+0x96b/0x3b50 arch/x86/include/generated/asm/syscalls_64.h:322
do_syscall_x64 arch/x86/entry/common.c:52 [inline]
do_syscall_64+0xcf/0x1e0 arch/x86/entry/common.c:83
entry_SYSCALL_64_after_hwframe+0x77/0x7f |
| Allocation of Resources Without Limits or Throttling vulnerability in Apache Tomcat.
This issue affects Apache Tomcat: from 11.0.0-M1 through 11.0.0-M20, from 10.1.0-M1 through 10.1.24, from 9.0.13 through 9.0.89.
The following versions were EOL at the time the CVE was created but are
known to be affected: 8.5.35 through 8.5.100 and 7.0.92 through 7.0.109. Other EOL versions may also be affected.
Users are recommended to upgrade to version 11.0.0-M21, 10.1.25, or 9.0.90, which fixes the issue.
Apache Tomcat, under certain configurations on any platform, allows an attacker to cause an OutOfMemoryError by abusing the TLS handshake process. |
| Squid is a caching proxy for the Web supporting HTTP, HTTPS, FTP, and more. Due to an Out-of-bounds Write error when assigning ESI variables, Squid is susceptible to a Memory Corruption error. This error can lead to a Denial of Service attack. |
| In MIT Kerberos 5 (aka krb5) before 1.21.3, an attacker can cause invalid memory reads during GSS message token handling by sending message tokens with invalid length fields. |
| In the Linux kernel, the following vulnerability has been resolved:
gpiolib: cdev: Fix use after free in lineinfo_changed_notify
The use-after-free issue occurs as follows: when the GPIO chip device file
is being closed by invoking gpio_chrdev_release(), watched_lines is freed
by bitmap_free(), but the unregistration of lineinfo_changed_nb notifier
chain failed due to waiting write rwsem. Additionally, one of the GPIO
chip's lines is also in the release process and holds the notifier chain's
read rwsem. Consequently, a race condition leads to the use-after-free of
watched_lines.
Here is the typical stack when issue happened:
[free]
gpio_chrdev_release()
--> bitmap_free(cdev->watched_lines) <-- freed
--> blocking_notifier_chain_unregister()
--> down_write(&nh->rwsem) <-- waiting rwsem
--> __down_write_common()
--> rwsem_down_write_slowpath()
--> schedule_preempt_disabled()
--> schedule()
[use]
st54spi_gpio_dev_release()
--> gpio_free()
--> gpiod_free()
--> gpiod_free_commit()
--> gpiod_line_state_notify()
--> blocking_notifier_call_chain()
--> down_read(&nh->rwsem); <-- held rwsem
--> notifier_call_chain()
--> lineinfo_changed_notify()
--> test_bit(xxxx, cdev->watched_lines) <-- use after free
The side effect of the use-after-free issue is that a GPIO line event is
being generated for userspace where it shouldn't. However, since the chrdev
is being closed, userspace won't have the chance to read that event anyway.
To fix the issue, call the bitmap_free() function after the unregistration
of lineinfo_changed_nb notifier chain. |
| In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: L2CAP: Fix not validating setsockopt user input
Check user input length before copying data. |
| REXML is an XML toolkit for Ruby. The REXML gem before 3.2.6 has a denial of service vulnerability when it parses an XML that has many `<`s in an attribute value. Those who need to parse untrusted XMLs may be impacted to this vulnerability. The REXML gem 3.2.7 or later include the patch to fix this vulnerability. As a workaround, don't parse untrusted XMLs. |
| FreeRDP is a free implementation of the Remote Desktop Protocol. FreeRDP based clients prior to version 3.5.1 are vulnerable to a possible `NULL` access and crash. Version 3.5.1 contains a patch for the issue. No known workarounds are available. |
| FreeRDP is a free implementation of the Remote Desktop Protocol. Prior to version 3.5.1, a malicious server can crash the FreeRDP client by sending invalid huge allocation size. Version 3.5.1 contains a patch for the issue. No known workarounds are available. |
| FreeRDP is a free implementation of the Remote Desktop Protocol. FreeRDP based clients prior to version 3.5.1 are vulnerable to out-of-bounds read if `((nWidth == 0) and (nHeight == 0))`. Version 3.5.1 contains a patch for the issue. No known workarounds are available. |
| FreeRDP is a free implementation of the Remote Desktop Protocol. FreeRDP based clients prior to version 3.5.1 are vulnerable to out-of-bounds read. Version 3.5.1 contains a patch for the issue. No known workarounds are available. |
| FreeRDP is a free implementation of the Remote Desktop Protocol. FreeRDP based based clients using `/bpp:32` legacy `GDI` drawing path with a version of FreeRDP prior to 3.5.0 or 2.11.6 are vulnerable to out-of-bounds read. Versions 3.5.0 and 2.11.6 patch the issue. As a workaround, use modern drawing paths (e.g. `/rfx` or `/gfx` options). The workaround requires server side support. |
| FreeRDP is a free implementation of the Remote Desktop Protocol. FreeRDP based clients and servers that use a version of FreeRDP prior to 3.5.0 or 2.11.6 are vulnerable to out-of-bounds read. Versions 3.5.0 and 2.11.6 patch the issue. No known workarounds are available. |
| FreeRDP is a free implementation of the Remote Desktop Protocol. FreeRDP based clients that use a version of FreeRDP prior to 3.5.0 or 2.11.6 are vulnerable to out-of-bounds read. Versions 3.5.0 and 2.11.6 patch the issue. As a workaround, use `/gfx` or `/rfx` modes (on by default, require server side support). |
| FreeRDP is a free implementation of the Remote Desktop Protocol. FreeRDP based clients that use a version of FreeRDP prior to 3.5.0 or 2.11.6 and have connections to servers using the `NSC` codec are vulnerable to integer underflow. Versions 3.5.0 and 2.11.6 patch the issue. As a workaround, do not use the NSC codec (e.g. use `-nsc`). |
| FreeRDP is a free implementation of the Remote Desktop Protocol. FreeRDP based clients using a version of FreeRDP prior to 3.5.0 or 2.11.6 are vulnerable to integer overflow and out-of-bounds write. Versions 3.5.0 and 2.11.6 patch the issue. As a workaround, do not use `/gfx` options (e.g. deactivate with `/bpp:32` or `/rfx` as it is on by default). |
| Improper initialization in UEFI firmware OutOfBandXML module in some Intel(R) Processors may allow a privileged user to potentially enable information disclosure via local access. |
